RF Optical Mouse Model #M301 User’s Manual Guide 1
User’s Manual Guide Hardware Installation 1.Connecting the receiver module For USB Interface Plug the receiver cable into the USB port of your system. System will automatically detect for new hardware. Follow system instruction for setup For USB and PS/2 Combo (If no USB port) Connect the PS/2 adaptor to the USB connector of the receiver. Restart your system.
Note: - - For optimal performance, place the receiver at least 8 inches (20 cm) away from any electronics devices (ex. computer, monitor, etc.) to avoid interference. If placing the receiver on metal surface, please use a non-metal pad under it. 2. Load batteries in optical mouse ( 2 AA batteries) 3. Syncranizing the receiver and wireless mouse 1. Press the connect button on the receiver. 2.
Troubleshooting Mouse does not work 1. Make sure the receiver cable is connected to the port correctly. 2. Check battery. 3. Press connect button on receiver, and then press the connect button on the mouse. 4. Make sure your mouse in not sitting on a red or highly reflective surface (ex. Mirror, glass, etc.) ID conflict. (When two mice have mutual interference) 1. Press connect button on receiver to select new ID. 2. Press connect button on bottom of the mouse.
FCC Warning! This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.