Setup User guide

Dangerous Music Monitor ST-SR for 7.1 setup guide

Daisy chain the RJ-45 cables

Wire the top SR as a normal 5.1 setup. The ST I/O loop

In a 7.1 setup, channels 3 and 4 become the is made with the top SR

Left Side and Right Side speakers. See the following pages for pictures and details.

The bottom SR has the Left Back and Right Back speakers

In a 7.1 setup. Use channels 3 and 4 on the ‘D’ subs for those connections.

The Remote plugs into the ‘Remote In’ jack

PAGE 1
Dangerous Music Monitor ST-SR for 7.1 setup guide Daisy chain the RJ-45 cables Wire the top SR as a normal 5.1 setup. The ST I/O loop In a 7.1 setup, channels 3 and 4 become the is made with the top SR Left Side and Right Side speakers. See the following pages for pictures and details. The bottom SR has the Left Back and Right Back speakers In a 7.1 setup. Use channels 3 and 4 on the ‘D’ subs for those connections.
PAGE 2
Channel name Analog In unit connector Pin #s hi, lo, sh 5.
PAGE 3
Dangerous Music Monitor ST-SR speaker assignment guide The Monitor ST and (2) Monitor SRs can be set up to accommodate stereo, 5.1, and 7.1 sessions. To use the same subwoofer in stereo and surround, use the “Speaker 3” output jack on the top Monitor SR, channel 6 for one sub and channels 7&8 for a two sub system. For 5.1, the Left Rear and Right Rear speakers are the same as the Left Surround and Right Surround in a 7.1 system. The following page has setup instructions to program the Monitor ST Remote.
PAGE 4
Once operational, the system will initially operate as a standard ST/SR arrangement capable of 5.1. The additional channels are activated from within the setup function. When setup is entered, select the additional channels you require by pressing the associated mute button. For 7.1, press the L Rear and R Rear buttons, lighting their LEDs. Once setup is exited, the mute control of the additional channels above 5.1 are accessed by pressing the PPI (Mute Shift) button.