User Manual TE-2018 Automatic Belt-Drive Turntable Instruction Manual Dear Customer, thank you very much for purchasing this record player. Before using this product, please read these instructions to prevent any damage, and keep it safe future reference.
IMPORTANT SAFETY INSTRUCTIONS This symbol indicates that This symbol indicates that dangerous voltage there are important constituting a risk of operating and maintenance electric shock is present instructions in the literature within the unit. accompanying the unit. 1. Read these instructions carefully. 2. Keep these instructions for future reference. 3. Take careful note of all warnings. 4. Follow all instructions carefully. 5. Do not use the unit near running water. 6.
BEFORE USING THEUNIT As the unit may become warm during operation, always leave sufficient space around the unit for ventilation. The voltage supplied to the unit should match the voltage as printed on the rear panel. If you are in any doubt regarding this matter, consult an electrician. Choose the installation location of your unit carefully. Avoid placing it in direct sunlight or close to a source of heat. Also avoid locations subject to vibrations and excessive dust, heat, cold or moisture.
Should the record become dirty, gently wipe the surface in a circular motion, using a soft anti-static cloth. Keep your records away from dust. Keep them in a cool, dry place. To avoid dust and scratches, keep records in their sleeves and jackets when not in use. Store records upright on their edges. Records stored horizontally will eventually bend and warp. Do not expose records to direct sunlight or high humidity and temperature. Long exposure to high temperatures will warp therecord.
9. Bluetooth/Phono/AUX mode selection knob 10. Power ON-OFF/Volume control knob 11. AUX in jack 12. Output Right channel 13. Output left channel 14. DC power input jack 15. Needle pressure regulator(Counterweight) 1. Dust Cover 2. 45 RPM adaptor 3. Tone arm 4. Tone arm lift lever 5. Speed selection switch 6. Auto stop ON/OFF switch 7. Stylus 8. Turntable Platter GETTING STARTED General Operation: 1.
Bluetooth function (Lift up the tone arm and put it on the Tone Arm Holder position) ● Turn on the Power ON-OFF/Volume button⑩, then adjust function selection button ⑨ to the BT position into the Bluetooth mode. Note: when the function selection button display the blue light,it is Bluetooth model ●Turn on the Bluetooth function of your device and enable the search or scan feature to find the Bluetooth pairing name “TE-2018”. Select "TE-2018" from the device list when it appears on your device screen.
MAINTENANCE How to replace the stylus The stylus should last about 50 hours under normal use. However, it is recommended that the stylus be replaced as soon as you notice a change in the sound quality Removing an old stylus: Installing a new stylus 1. Set a screwdriver at the tip of the stylus andpush down to the direction "A". 1. Hold the tip of the stylus and insert the other edge by pressing toward direction"C". 2. Pull the stylus out toward direction "B". 2.
Speaker Driver 15W *2 Dimensions (each speaker) L370*W285*142mm Power DC12V Inputs 1 x 3 .5 mm stereo mini-jack 2A 1 x Bluetooth Power Output 30Watts 3 Speeds 33; 45; 78 rpm Auto stop Auto Stop ON or OFF Accessories User Manual x1; Adaptor(DC12V2A) x1; Dust cover x1; 45RPM Adaptor TROUBLE SHOOTING GUIDE PROBLEM POSSIBLE CAUSE REMEDY GENERAL No sound in general. Volume not adjusted. Adjust the Volume knob. Source mode in wrong position.