User's Manual

ManualsBrandsDANBY PRODUCTS ManualsElectronicsHive Module

Hive Module User Manual

Purpose

The intent of this document is to provide step-by-step instructions on how to start a hive module

to a nearby 2.4 GHz WI-Fi access point.

Note: This Hive Module should be used with Danby Host device only.

Required Materials

 Smart phone running Android version greater than 5.0

 Hive Module Onboarding App

 12V DC Powered Hive module. The Hive Module board will display a purple LED when it is booted

and ready to connect to a wireless access point.

 Take special note of the MAC address displayed on the label which will be on top face of the Hive

Module mechanical housing.

Technical specifications

Qualcomm 2.4 GHz Single band Wi-Fi Chipset (IEEE 802.11 b/g/n)

1GB RAM

8GB eMMC as a Memory

Processor Qualcomm Snapdragon APQ8009

High Resolution Camera 5MP

DC Power and Peripheral Connector on board

12VDC operated board

Instructions

1. Open the latest version of the Onboarding App, on an appropriate device.

2. The app will automatically attempt to detect nearby Hive Module. Please wait to allow for

discovery. If the app fails to detect a Hive Module, proceed to the troubleshooting section.

3. When a Hive Module is discovered, click on the mailbox field. If multiple Hive Modules are

detected, make sure to select the correct device, discernible by the MAC address written on the

top of the PCBA case.

Summary of content (5 pages)

PAGE 1
Hive Module User Manual Purpose The intent of this document is to provide step-by-step instructions on how to start a hive module to a nearby 2.4 GHz WI-Fi access point. Note: This Hive Module should be used with Danby Host device only. Required Materials     Smart phone running Android version greater than 5.0 Hive Module Onboarding App 12V DC Powered Hive module. The Hive Module board will display a purple LED when it is booted and ready to connect to a wireless access point.
PAGE 2
4. Click the connect button. Wait for the Wi-Fi icon to appear on the top icon ribbon on the phone screen. The Wi-Fi symbol will have an exclamation mark beside it. Not waiting for this step will crash the app. 5. Ensure directional antenna is oriented in approximately the correct direction in the Hive Module unit. It should be angled towards the location of a Wi-Fi connection’s broadcasting router. Click the configure Wi-Fi button. This will bring up a list of connectable Wi-Fi hotspots. 6.
PAGE 3
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 4
Déclaration d'Innovation, Sciences et Développement économique Canada (ISED) L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 1. L’appareil ne doit pas produire de brouillage; 2.
PAGE 5
This radio transmitter [IC: 25031-Z00718] has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.