Installation Instructions

ManualsBrandsDamm Cellular Systems ManualsElectronics410 MHZ TRANSCEIVER MODULE

Doc. No.

Rev.

Date

D100200-REF

1.02

2012-10-09

Damm Cellular Systems A/S, Denmark

BS414 Base Station

Page 1 of 7

1.1 BS414 BASE STATION - 4 CARRIER

Description

DAMM BS414 is a 4-carrier TETRA indoor base station and is complementary to DAMM

BS421 and DAMM BS411 TETRA base stations. The BS414 may be used in networks where

medium traffic capacity is required (up to 15 Erlang).

It is designed for a fully IP based connectivity and allows for remote supervision and

diagnostic, test, control, setting and software update, file transfer and SNMP. Its embedded

Operate & Maintenance (OM) system is reached by means of Windows desktop.

The BS414 support discontinuous transmission fully GPS synchronized. This allows a

dramatic decrease in power consumption, as only the active TR412 (‘s) needs to be

powered, until traffic load requires more carriers to be on air.

BS414 fully supports Voice + Data services in full and half duplex modes, compliant with the

ETSI EN 300 392

Access to all field replaceable units (FRU) is from the front, protected by a lockable door, and

all external connectors in located on top of the rack.

The BS414 consist of the base station controller, the transceiver modules, the combiner

system and the filter system. In the receiver path a separate Tower Mounted

Amplifier/Duplexer (TMD412) is an integrated functional part of BS414.

Summary of content (7 pages)

PAGE 1
Damm Cellular Systems A/S, Denmark Doc. No. Rev. Date D100200-REF 1.02 2012-10-09 BS414 Base Station 1.1 BS414 BASE STATION - 4 CARRIER Description DAMM BS414 is a 4-carrier TETRA indoor base station and is complementary to DAMM BS421 and DAMM BS411 TETRA base stations. The BS414 may be used in networks where medium traffic capacity is required (up to 15 Erlang).
PAGE 2
Damm Cellular Systems A/S, Denmark Doc. No. Rev. Date D100200-REF 1.02 2012-10-09 BS414 Base Station The TMD412 is intended for mast/tower mounting. Substantially the unit is a receiver amplifier, but can be coupled as an amplifier with build in duplex filter. Using the TMD412 in Duplex mode needs to take into consideration the numbers of carriers and frequencies used, in order to eliminate potential interference.
PAGE 3
Damm Cellular Systems A/S, Denmark Doc. No. Rev. Date D100200-REF 1.02 2012-10-09 BS414 Base Station Transceiver, TR412 The TR412 Transceiver is a complete TETRA carrier unit The TX section contains a linear, low noise transmitter linearized with a Cartesian loop. It can deliver a peak output power of 60W, giving a nominal output power of 25W TETRA . Modulation and power control is performed in software of the DSP.
PAGE 4
Damm Cellular Systems A/S, Denmark Doc. No. Rev. Date D100200-REF 1.02 2012-10-09 BS414 Base Station Antenna Interface, AI411. The AI411 Antenna Interface unit is used in all Base Station (BS411and BS414) and contains all the necessary circuit to support a complete Radio Cell including support of the Tower Mounted Amplifier/Duplexer TMD412 with all functions. The two independent RX multi-coupler amplifiers are built with low-noise high dynamic range transistors.
PAGE 5
Damm Cellular Systems A/S, Denmark Doc. No. Rev. Date D100200-REF 1.02 2012-10-09 BS414 Base Station Figure 2: DAMM BS414 (BS411) TX/RX Signal Paths DAMM BS414 (BS411) TX/RX Signal Path Control and Power connections not shown TMA TMA TX/RX-A RX-A TX RX-B 1. 2. RX-A 0,6dB 0,8dB TMA/TMD412 RX-B 1=TMA 1+2 = TMD GPS TX Test Refl.
PAGE 6
Damm Cellular Systems A/S, Denmark Doc. No. Rev. Date D100200-REF 1.
PAGE 7
Damm Cellular Systems A/S, Denmark Doc. No. Rev. Date D100200-REF 1.