User's Manual

Driveway Radio User Manual

UT-3000 Transmitter:

The UT-3000 transmitter has several methods of activation. First, it has a push button that can be

used as a panic button or doorbell. It also has terminals for a normally open (N/O) or normally

closed (N/C) input. When the transmitter is activated, it will send a signal to the receiver which

will sound one of four different tones (Classical, Westminster Chime, Ding Dong, or Whistle) for a

few seconds, or activate the relay outputs.

Operation:

Swing open the bottom of the front cover to reveal the battery connector, dip switches and input

terminals.

Connect a 9V alkaline battery to the transmitter.

Set the dip switches 1-8 on the transmitter module to match the receiver.

Set dip switches 9 and 10 to control the desired zone, tune, and relay output.

Operation:

Power ON/OFF

Press the side button 2 seconds for Power ON or Power OFF.

Time Setting

Press Side Button once, the receiver goes into the Time Setting mode. Press the left button on the

front to the digit you want to change, and press right button on the front to modify the number.

After modification, press side button to save the setting and move to Vibration Setting mode.

Vibration

Press side button twice, the receiver goes into the Vibration Setting mode. Press right button to

change it ON/OFF.

Beep / Silent

Press Side Button 3 times, the receiver goes into Beep / Silent mode. Press right button to change

ON/OFF.

ID Code Checking

Press Side Button 4 times to check the ID code you have already set. The ID code must be same

as the transmitter.

Alarm

Normally, the display shows the time. It also receives signals from transmitter automatically.

When there is an alarm, the receiver will do the following:

PAGE 1
Driveway Radio User Manual UT-3000 Transmitter: The UT-3000 transmitter has several methods of activation. First, it has a push button that can be used as a panic button or doorbell. It also has terminals for a normally open (N/O) or normally closed (N/C) input. When the transmitter is activated, it will send a signal to the receiver which will sound one of four different tones (Classical, Westminster Chime, Ding Dong, or Whistle) for a few seconds, or activate the relay outputs.
PAGE 2
1). Record the time and channel (up to 9999 / channel); 2). Display the time and channel (up to 250 / channel); 3). Give alarm by vibration or Beep according to the setting of the unit. Channel 1 has one beep sound, channel 2 two beeps, channel 3 3beeps, and channel 4 four beeps. 4) The display can only be cancelled by the user (press DN) or there is a new alarm to cover the old one.