TM Dakota Alert WIRELESS SECURITY EQUIPMENT Wireless PIR Senor PIR-4000 USER GUIDE www.dakotaalert.
The PIR-4000 transmitter is compatible with all Dakota Alert 4000 series receivers. The PIR-4000 is designed for indoor applications or outdoor applications in a protected area such as an eve. When the sensor detects an object it will send a signal to a receiver which will sound one of the selected tunes for few seconds. PACKAGE CONTENTS • • • • • PIR (1) CR123 A Swivel Mount Screws (2) User Guide SETTING UP YOU IR-4000: 1. 2. 3. 4. Adjust the PIR-4000 Chrome-extension settings.
FRONT VIEW SIDE VIEW 3
ADJUSTING MOTION DETECTOR SETTINGS To adjust your settings, move the jumpers inside the motion detector’s case to complete a circuit. 1. To open the case, locate the small tab on the bottom of the case and press with a small flat screwdriver while pulling the lens portion of the case away from the back portion of the case. 2. Locate the set of jumpers in the bottom left hand corner of the circuit board.
3. Gently pull off the jumper for the setting you want to change. Note: If you can’t move the jumper with your fingers, you can use a tweezers. 4. Gently slide the jumper back onto the pair of jumper pins that corresponds with the setting you want.
JUMPER SETTINGS • RESET: Changes the minimum time between alarm activations. 10S 120S 10S (10 Seconds): Waits 10 seconds before the alarm activates again 10S 120S 120S (120 Seconds): Waits 120 seconds before the alarm activates again • LED: Turns LEDs on or off ON OFF ON: LED lights for 2 seconds when motion is detected.
INSTALLING THE BATTERY 1. Open the case by pressing the small tab at the bottom of the case with a small screwdriver. 2. Connect a CR-123A battery (included) to the PIR-4000. Be sure to observe the polarity (+/-) on the case. Battery 3.
CODING TO YOUR RECEIVER NOTE: You can connect up to 16 transmitters to your receiver 1. Refer to the manual for you Dakota Alert 4000 Series receiver for complete coding instructions. 2.
MOUNTING YOUR PIR-4000 NOTE: For maximum range between the motion detector and receiver, avoid mounting the sensor on a metal object. Although the maximum range is about one mile, obstructions such as hills, trees, metal siding and stucco can reduce that range. 1. Select a location to mount the motion detector. For best results mount the sensor on a wall about 7’ off the ground and pointing down slightly at the area to be monitored. Avoid pointing towards things that move such as curtains in the wind. 2.
SPECIFICATIONS • Power Source: CR-123A lithium battery • Motion detection range: up to about 40’ • Wireless Range: Up to 1 mile (1.6 km)* • Dimensions 3.25” H X 2” W X 1.5” D • Operating Temperature: -10° to 120° F (-23° to 49° C) • Operating Frequencies: 433 MHz *Actual range will vary depending on local terrain and obstructions. TECH SUPPORT If you have problems using this product after reading this manual, please contact us.
LEGAL NOTICES This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) the device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.
Dakota Alert, Inc. www.dakotaalert.com Phone: (605)356-2772 Fax: (605)356-3662 Address: 32556 477th Ave.