Owner's Manual

ManualsBrandsDa-Lite ManualsAccessoriesDa-Lite 99622 Projector Interface

DA-LITE SCREEN COMPANY, INC.

3100 North Detroit Street

Post Office Box 137

Warsaw, Indiana 46581-0137

Phone: 574-267-8101

800-622-3737

Fax: 574-267-7804

Toll Free Fax: 877-325-4832

www.da-lite.com

e-mail: info@da-lite.com

POWER

PRESENTATION PRODUCTS

The

Installation Instructions for

VIDEO PROJECTOR INTERFACE

Summary of content (4 pages)

PAGE 1
The POWER In PRESENTATION PRODUCTS Installation Instructions for VIDEO PROJECTOR INTERFACE DA-LITE SCREEN COMPANY, INC. 3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 574-267-8101 800-622-3737 Fax: 574-267-7804 Toll Free Fax: 877-325-4832 www.da-lite.com e-mail: info@da-lite.
PAGE 2
VIDEO PROJECTOR INTERFACE INSTALLATION The Video Projector Interface (VPI) housing is divided into three compartments. The compartment labeled “Low Voltage Connections” is where you will connect the VPI to the projector’s output and wall switch wire connections. The compartment labeled “AC Power Connections” is where the main power and motor wire connections are made. Access is not required to the center compartment.
PAGE 3
AC POWER CONNECTIONS Screen Motor 1. Using 4-conductor, 14-18 gauge wire, extend the motor wires from the screen junction box to the length required to reach the VPI. 2. Connect the extended wires from the screen motor to the VPI wires that are labeled “motor wires”. Refer to Figure 2. 120V 240V SCREEN MOTOR SCREEN MOTOR GREEN WHITE BLACK GROUND LUG GREEN/YELLOW BLUE BROWN RED GROUND LUG BLACK RECOMMENDED WIRE SIZE: 14-18 AWG RECOMMENDED WIRE SIZE: 14-18 AWG FIGURE 2 AC Power Source 1.
PAGE 4
AC POWER CONNECTIONS Wall Switch 1. Using 3-conductor, 20-24 gauge wire, extend the wall switch wires from the back of the wall switch to the length required to reach the VPI. 2. Connect the extended wires from the wall switch to the VPI wires that are labeled “wall switch”. Refer to Figure 4.