Installation & Assembly_1

Installation Instructions for your D’Vontz

Copper Kitchen Sink

Items needed for Installation:

• A quality 100% clear silicon sealer.

• Sink drain for appropriate drain diameter. (D’Vontz or Westbrass)

• Soft cotton rag.

• Pencil

• Tape Measure

Directions:

Drop In Installation:

• Since these sinks are manufactured by hand, we are unable to provide a

template due to variations that occur in size.

• Determine location on countertop for sink. Turn sink upside down and place on

countertop. Lightly trace the outside edge of your sink with a pencil. Remove

sink and scribe line with pencil 2” inside outside line. See Fig. A. Cut countertop

to this dimension.

Fig. A

• Once countertop hole is cut, set sink inside hole and center. Ensure sink flange

sits flat on top countertop.

Pencil Trace Line

Countertop Cut Line

PAGE 1
Installation Instructions for your D’Vontz Copper Kitchen Sink Items needed for Installation: • • • • • A quality 100% clear silicon sealer. Sink drain for appropriate drain diameter. (D’Vontz or Westbrass) Soft cotton rag. Pencil Tape Measure Directions: Drop In Installation: • Since these sinks are manufactured by hand, we are unable to provide a template due to variations that occur in size. • Determine location on countertop for sink. Turn sink upside down and place on countertop.
PAGE 2
• Before setting sink in countertop, prepare and attach drain to sink. Use silicone sealer under drain flange. After tightening tailpiece remove excess sealer. • Run a ¼” bead of silicon sealant inside of pencil line. Carefully set sink into countertop hole and sealant. Once positioned, carefully remove excess sealant from the outside rim of sink with a soft cotton rag while holding downward pressure on sink.
PAGE 3
Copyrights 2005 D’Vontz L.L.C.