Quick Installation Guide

Pro Series

Battery-powered Remote

Water Sensing Pod Add-on

for the Whole Home Smart Wi-Fi Water Leak Sensor Kit

DCH-S163 A1

Setup Code

This is your device’s Setup Code.

Please keep it as future reference

for your device.

Simple Setup

Get the mydlink app on the App Store

or on Google Play. Launch the app, then

mydlink

Tap then tap Add a Device.

Note: Make sure that your DCH-S162 hub is

set up and functioning properly beforehand.

Tap Scan, then scan the Setup Code

located in the Setup Code section.

Follow the app instructions to set up

your device with your DCH-S162 hub.

Note: This is an add-on to the Pro Series Whole

Home Smart Wi-Fi Water Leak Sensor Starter Kit. The

DCH-S162 is required for this device to function.

(pre-installed)

PAGE 1
DCH-S163 A1 Pro Series Battery-powered Remote Water Sensing Pod Add-on for the Whole Home Smart Wi-Fi Water Leak Sensor Kit Quick Installation Guide Simple Setup Note: Make sure that your DCH-S162 hub is set up and functioning properly beforehand. 1 Get the mydlink app on the App Store or on Google Play. Launch the app, then Sign In or Create a New Account. mydlink Note: This is an add-on to the Pro Series Whole Home Smart Wi-Fi Water Leak Sensor Starter Kit.
PAGE 2
LED Behavior FAQ Status LED Waiting to pair Water leak detected What do I do if my device is not working properly? Reset and reinstall your device.
PAGE 3
Attention FCC: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.