User Manual

ManualsBrandsCYOEST ManualsElectronicsDIY Wireless Bluetooth Speaker STEM Project Kit Electronics Learning and Teaching | Great Science Project and Gift for Kids Teens Adults | NO Soldering

If you have any problem, please contact us and we will

solve it perfectly within 24 hours

KEY POINT1:Make sure you know how the circuit is connected before starting the installation.

Incorrect connection can cause damage to the Bluetooth board.

KEY POINT2:All small parts have a mark（a b c d

e ), please pay attention.

KEY POINT3:The appearance of the assembled

speaker

z-horse bluetooth spaker

Summary of content (6 pages)

PAGE 1
If you have any problem, please contact us and we will solve it perfectly within 24 hours KEY POINT1:Make sure you know how the circuit is connected before starting the installation. Incorrect connection can cause damage to the Bluetooth board. z-horse bluetooth spaker KEY POINT2:All small parts have a mark（a b c d e ), please pay attention.
PAGE 2
With the key points in mind, let's assemble,patience is essential. step1:Install the battery case with double-sided adhesive tape or glue(not included) step2:Install the speakers with eight 4MM(short) screws.Notice red circles step3:Install two side panels..Notice red circles.
PAGE 3
If you have any problem, please contact us and we will solve it perfectly within 24 hours step4:Install the battery pack panel. Notice red circles. step5:Use 2 thumbs to push the switch into the position according to the picture step6:Connect red wire of the switch to red wire of the power supply wire.(Only one wire can connect) step7:Connect a wire from battery pack to the left switch wire,the other to the power supply wire.
PAGE 4
If you have any problem, please contact us and we will solve it perfectly within 24 hours. step8:Install the top plate according to the picture. step9:Install the bluetooth board with two 6MM screws.(long) step10:Connect 2 speakers wires to “White” and power supply wires to “red” on Bluetooth board. step11:Install the bottom plate.
PAGE 5
If you have any problem, please contact us and we will solve it perfectly within 24 hours step12:Install the owl's eyes with part”d” step13:Install 4 ”a” to install the feather d step14:Install the feathers.
PAGE 6
If you have any problem, please contact us and we will solve it perfectly within 24 hours step16:Install ”b” on the owl's feet b step17:Install the owl's feet b step18:Install 4 batteries (not included) push the switch to ON.