User's Manual

Broadband Security Router User Guide
- 48 -
selecting Router’s private IP Address or from the WAN side
by selecting Router’s WAN IP Address.
Destination IP:
Enter the IP Address of destination device you want to ping.
If Router’s LAN IP address is selected as Source IP, you only
can ping LAN side device and vice versa.
Packet Number:
Enter the packet numbers you wish to use to ping the
destination device. The maximum numbers are four.
Packet Size:
Enter the numbers of packet size you wish to use to ping the
destination device. The maximum packet sizes are 1514.
Time Between
Enter the numbers of time between two packets.
Time out:
Enter the number of time regarding as no response after
starting to ping the destination device.
Start:
Click this button to begin the ping test.
Ping Result:
The result will show the numbers of sending packet, numbers
of packet receiving, and the average return time.
Tracert
To trace the route between the router and a certain device, you can type in the IP
address of that device on the box of Tracert host and click the “Tracert” button. The
status of the connection will be sown on the field of Trace Message.
Tracert Host:
Enter the IP Address of destination device that you wish to
trace the route between Router and that device.
Trace Message:
The result shows the routing information between Router and
destination device.
Tracert:
Click “Tracert” to start this test.