User's Manual

Broadband Security Router User Guide
- 7 -
Chapter 2: Installation
This chapter provides information about your High-Performance Wireless Router’s
physical features and gives step-by-step installation instructions for hardware
installation and software configuration.
Front Panel
The following figure shows the front view of the High-Performance Wireless Router.
The LEDs on the front panel indicate the status of the unit. You can easily view the
operation of your High-Performance Wireless Router from this panel.
Note: Please refer to the model on your hand to find proper description.
LED Status Description
Power: Green Steady on when the power is on.
Diag: Red Lights up during system checking connections and
internal operation when the power is first switched
on. If the device works properly, the light should
switch off automatically.
WLAN
Link/Act:
Green ¾ Steady on when the wireless AP is enabled.
When the wireless AP is disabled (through the
web-based utility), the LED should remain off.
¾ Blinking when data is flowing through Wireless
AP.
WAN
Link/Act:
Green ¾ Steady on when the Ethernet link exists.
¾ Blinking when data is flowing through this port.
LAN 1~4
Link/Act:
Green ¾ Steady on when the Ethernet link exists.
¾ Blinking when data is flowing through this port.