Quick Start Guide Cisco Small Business RV130 Multifunction VPN Router RV130W Wireless Multifunction VPN Router Package Contents • Router • Ethernet Cable • Power Adapter • Quick Start Guide • Documentation and Software on CD-ROM Versión en Español para México en el CD Version en français sur CD Versione italiana sul CD Deutsch Version auf CD
Welcome Thank you for choosing the Cisco Small Business RV130/RV130W router. This guide describes how to physically install your Cisco RV130/RV130W and launch the web-based Device Manager. 1 Mounting the Cisco RV130/RV130W Placement Tips To prevent the device from overheating or being damaged: • Ambient Temperature—Do not operate it in an area that exceeds an ambient temperature of 104°F (40°C). • Air Flow—Be sure that there is adequate air flow around the device.
2 Cisco RV130/RV130W Features RV130 Front Panel Power Solid green when the device is powered on and booted. Flashes green when the device is booting or upgrading the firmware. VPN Flashes rapidly if the device is running corrupt firmware. Solid green when at least one VPN tunnel is active. (for site-to-site IPsec VPN only) Flashes green when receiving or transmitting data through a VPN tunnel. USB Amber when no enabled VPN tunnel is active.
WAN Solid green when the device is connected to the Internet using a wired connection. Off when the device is not connected to the Internet or is connected using a USB dongle. LAN (1-4) Flashes green when sending or receiving data over the wired connection. RJ-45 connectors that link local area network devices, such as PCs, print servers, or switches, to the device. The numbered lights correspond to the LAN ports on the back panel. Solid green when the corresponding port is connected to a device.
WLAN Lit green when the wireless radio is enabled. Off when the wireless radio is switched off. WAN Flashes green when transmitting or receiving data using a wireless connection. Lit green when the device is connected to the Internet using a wired connection. The light is off when the device is not connected to the Internet or is connected using a USB dongle.
RV130/RV130W Back Panel RESET The RESET button has two functions: • To reboot the unit and retain the current configuration, press and hold RESET for at least 3, but no more than 10 seconds, by using a paper clip or a pen tip. • To reboot the unit and restore the factory default configuration, press and hold the RESET button for more than 10 seconds. Changes you have made to the Cisco RV130/ RV130W configuration are lost.
Connecting the Equipment 3 You must connect a PC to the device by using an Ethernet cable to perform the initial configuration. After the initial configuration, administrative tasks can be performed through the network or by using a wireless connection. To connect a PC to the device for initial configuration: STEP 1 Power off all equipment, including the cable or DSL modem, the PC, and the device. STEP 2 Use an Ethernet cable to connect your cable or DSL modem to the WAN port on your device.
4 Using the Setup Wizard The Setup Wizard and Device Manager are supported on Microsoft Internet Explorer 7.0 or later, Mozilla Firefox 3.5 or later, Apple Safari 3.0 or later, and Google Chrome 5.0 or later. To configure the device by using the Setup Wizard: STEP 1 Power on the PC that you connected to the LAN1 port in Step 3 of the Connecting the Equipment section. Your PC becomes a DHCP client of the device and receives an IP address in the 192.168.1.xxx range.
Changing the Administrator Username and Password To change the administrator username and password on the device: STEP 1 From the Getting Started page, select Change Default Administrator Password or select Administration > Users. STEP 2 Check Edit Admin Settings. STEP 3 Enter a new username in Administrator Account Settings. We recommend that you do not use cisco. STEP 4 Enter the old password. STEP 5 Enter the new password.
5 Where to Go From Here Support Cisco Small Business Support Community Cisco Small Business Support and Resources Phone Support Contacts Cisco Small Business Firmware Downloads www.cisco.com/go/smallbizsupport www.cisco.com/go/smallbizhelp www.cisco.com/en/US/support/ tsd_cisco_small_business _support_center_contacts.html www.cisco.com/cisco/software/ navigator.html?i=!ch Select a link to download firmware for Cisco Small Business Products. No login is required.
Cisco Small Business RV130/RV130W Mutlifunction VPN Router 11
Americas Headquarters Cisco Systems, Inc. 170 West Tasman Drive San Jose, CA 95134-1706 USA www.cisco.com Small Business Support, Global: www.cisco.com/go/sbsc Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners.
