Quick Start Guide REMOTE MANAGEMENT CARD RMCARD205 RMCARD305 The Remote Management Card allows a UPS system and environmental sensor to be managed, monitored, and configured.
INSTALLATION GUIDE Step 1. Hardware Installation RMCARD205 RMCARD305 1. Remove the two retaining screws of the expansion port cover, and then remove the cover. 2. Install the CyberPower Remote Management Card into the expansion port. 3. Re-install and tighten the retaining screws. 4. Connect the Ethernet cable to the Ethernet connector of the CyberPower Remote Management Card. 5. (Optional) To connect with the environmental sensor, use a RJ45 Ethernet cable.
Definitions for LED Indicators Link LED color Off On(Yellow) TX/RX LED color Off On(Green) Flash Condition The Remote Management Card is not connected to the Network/ or the Remote Management Card power is off The Remote Management Card is connected to the Network The Remote Management Card power is off The Remote Management Card power is on - Receiving/transmitting data packet - Reset finished Step 2. Configure the IP address for the CyberPower Remote Management Card.
2. After installation completes, run the “Power Device Network Utility”. 3. The main dialog of the Power Device Network Utility Tool program is shown in Figure 1. The configuration tool will display all CyberPower Remote Management devices present on the same network subnet. The "Refresh" button is used to search the local network subnet again. Figure 1. The main window of the “Power Device Network Utility” program. 4. Select the Remote Management Card you are setting up.
7. You will need to enter a User Name and Password for the Remote Management Card in the authentication window, as shown in Figure 3. *Default user name: cyber Default password: cyber Figure 3. Authentication window. 8. If the IP address change is successful, you will see a message confirming the IP set up is OK, as shown in Figure 4. Figure 4. Setup IP Address successfully message. Method 2: Using a command prompt 1. Obtain the MAC address from the label on the Remote Management Card.
WEB INTERFACE Login User Account You can select a preferred language, and will need to enter a User Name and Password to login to the interface. There are two user account types. 1. Administrator *Default username: cyber Default password: cyber 2. View only *Default username: device Default password: cyber The administrator can access all functions, including enable/disable the view only account. The viewer can access read only features but cannot change any settings. Trouble Shooting Problem Solution 1.
SOFTWARE SUPPORT PowerPanel® Business Edition Client can support a UPS with a remote management card via the network. PowerPanel® Business Edition software is available on CyberPower Systems official website. Please visit www.CyberPower.com and go to the software section for free download. CONFORMANCE APPROVALS FCC Warning This equipment has been tested and found to comply with the limits for a Class A Digital Device, pursuant to Part 15 of the FCC Rules.
CyberPower North America CyberPower Systems (USA), Inc. Phone: (952)-403-9500 Toll-free: (877)297-6937 4241 12th Avenue E. Suite 400, Shakopee, MN 55379 E-mail: tech@cpsww.com Website: www.CPSww.com CyberPower International CyberPower Systems, Inc. Website: www.CyberPower.
