Other

110V/15 amp spas are supplied with a power cord but must be connected to a weatherproof 15A outlet. A1

220v/50 amp spa must be hardwired directly to your house supply. All 220v/50 amp electrical connections

must be performed by a licensed electrician and must confirm to all national, state and local electrical

codes in effect at time of install.

DO NOT turn power ON to the spa until it is filled with water.2

Check that unions are tight and check gate valves are open.3

Remove the cabinet door panel on the electronic keypad side of the spa and check that the pump(s) and

heater barrel unions are tightened. It is possible for these connections to become loose during transporta-

tion). Also check that all gate (T-handled) valves are pulled UP in the open position and have a clip locked

into place.

NOTE: If you see water escaping from beneath your spa, the unions should be the first thing you check.

LEAKS FROM UNIONS ARE NOT COVERED BY THE SPA’S WARRANTY.

Ensure that the external drain valve is firmly tightened and the jets are in the open position. 4

Refer to illustrations below.

Remove the filter from the spa and insert your garden hose down the filter line for at least 5 minutes.5

This will flood the plumbing lines of the spa and help prevent an air lock.

Clip is secured into proper position.

External drain is located in the bottom right corner of the spa (Round spa drain is located inside the spa cabinet).

Adjustable jets will rotate clockwise (on)

or counter-clockwise (off)

INITIAL START-UP PROCEDURE & CHECKLIST

Wayfair Startup Guide.qxp_Layout 1 8/1/19 3:32 PM Page 1

PAGE 1
Wayfair Startup Guide.qxp_Layout 1 8/1/19 3:32 PM Page 1 INITIAL START-UP PROCEDURE & CHECKLIST 1 110V/15 amp spas are supplied with a power cord but must be connected to a weatherproof 15A outlet. A 220v/50 amp spa must be hardwired directly to your house supply. All 220v/50 amp electrical connections must be performed by a licensed electrician and must confirm to all national, state and local electrical codes in effect at time of install. 2 DO NOT turn power ON to the spa until it is filled with water.
PAGE 2
Wayfair Startup Guide.qxp_Layout 1 8/1/19 3:32 PM Page 2 6 Your spa should be filled 2/3 of the way up the skimmer opening. Please see diagram for proper water level. 7 For 110v/15 amp spas, once the spa has been filled with water to the correct level, plug the power cord into the recepticle and be sure that the reset button has been pressed on both the wall recepticle and the plug’s GFCI. 8 For 220v spas, switch the spa ON at the GFCI breaker switch.