User's Manual

ManualsBrandsCUSTOM AUTOSOUND MFG ManualsElectronicsslidebar radio

User's Manual

THE ORIGINATOR OF CLASSIC

VEHICLE OEM FIT RADIOS

SINCE 1977

SLIDEBAR

RADIO

LIMITED WARRANTY

If your product does not work properly because of a defect in material or work-

manship, Custom Autosound Mfg.,Inc. (the Company) will for the length of the

period indicated on the chart below, which starts with the date of original pur-

chase (“Limited Warranty period”), at its option either (a) repair your product with

new or refurbished parts, or (b) replace it with a new or refurbi

shed product. The

decision to repair or replace will be made by the company.

During the “Labor” Limited Warranty period there will be no charge for labor.

During the “Parts” Limited Warranty period, there will be no charge for parts. This

Limited Warranty is extended only to the original purchaser and only covers

product purchased as new. A purchase receipt or other proof of the original pur-

chase date

is required for Limited Warranty service.

To obtain repairs or replacement within the terms of this warranty, the product

should be delivered, transportation prepaid, to the Company at the address

shown below.

This warranty does not extend to the elimination of car static or motor noise cor-

rection, antenna problems, costs incurred for removal or reinstallation of product,

or damage of tapes, speakers

accessories or car electrical systems.

This warranty does not apply to any product or part thereof which has been

damaged through alteration, mishandling, misuse, neglect, or accident.

ANY IMPLIED WARRANTY IS LIMITED TO THE DURATION OF THIS WRIT-

TEN WARRANTY. UNDER NO CIRCUMSTANCES SHALL THE COMPANY BE

LIABLE FOR ANY LOSS OR DAMAGE, DIRECT OR CONSEQUENTIAL, ARIS-

ING OUT OF THE USE OR INABILITY TO USE

THIS PRODUCT: No person or

representative is authorized to assume for the Company any liability other than

expressed herein in connection with the sale of this product.

Some states do not allow limitations on the length of an implied warranty or the

exclusion or limitation of incidental or consequential damage to the above limita-

tions or exclusion may not apply to you.

This warranty gives you specif

ic legal rights and you may also have other rights

which vary from state to state.

1030 W. Williamson Ave. Fullerton CA. 92833

800-888-8637 714-773-1423 FAX 714-773-1523

Product or Part Name PARTS LABOR

All In-dash car radios, radio/tape

player combinations.

Two (2) Years One (1) Year

HIGH POWER 300 WATTS

AM/FM with RDS & 25 Pre-sets

7 LCD Color Choices (selectable)

CD Controller

Auxiliary In

Subwoofer Line out w/ x-over

Front/ Rear Fader

Left/Right Balance

Bass / Mid / Treble Control

DSP EQ

Clock

USB Jack charge for mobile phones

USB MP3/WMA Player

Loudness Function

Last Volume Memory

RCA Pre-out 5v (2 Pair)

Auto Antenna lead

AM/FM WITH RDS TUNER,

BLUE TOOTH and HIDEAWAY DISPLAY

READY TO INSTALL IN YOUR ORIGINAL DASH

NO ASSEMBLY REQUIRED!

Slidebar Manual_new_USA-5_manual_peter 1/23/2014 9:19 AM Page 1

BlueTooth

/FLAC/WAV

Summary of content (11 pages)

PAGE 1
Slidebar Manual_new_USA-5_manual_peter 1/23/2014 9:19 AM Page 1 LIMITED WARRANTY User's Manual If your product does not work properly because of a defect in material or workmanship, Custom Autosound Mfg.,Inc. (the Company) will for the length of the period indicated on the chart below, which starts with the date of original purchase (“Limited Warranty period”), at its option either (a) repair your product with new or refurbished parts, or (b) replace it with a new or refurbished product.
PAGE 2
Slidebar Manual_new_USA-5_manual_peter 1/23/2014 9:19 AM Page 2 This radio is for 12volt negative ground vehicles only. If your electrical system is 6volts and or positive ground Custom Autosound has power inverters #PGPIHC (positive ground power inverter) and voltage boosters #NGVB-HC (negative ground voltage booster) for use with this radio. Table of Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 General Installation . . . . . . . . . . . . . . . . . . . . .
PAGE 3
Slidebar Manual_new_USA-5_manual_peter 1/23/2014 9:19 AM Page 3 Antenna Noise cont. Elimination 1. Test or have tested the antenna lead for any breaks or shorts.Signs of crimping, . . kinking, fraying or rust usually indicates damage to the cable.Replace the antenna or cable if necessary. Ignition Noise A popping or crackling noise heard through the speakers. The noise will vary as the engine rpm varies,The noise will Only be present with the engine running Elimination 1. Install an L.C.
PAGE 4
Slidebar Manual_new_USA-5_manual_peter 1/23/2014 9:19 AM Page 4 Radio Installation Thank you for your purchase of this Custom Autosound product! Owner- Installer: Please review installation instructions and owners manual. Keep in mind that your radio and/or speakers are custom equipment designed specifically for your year vehicle. It should be handled carefully and installed preferably by an auto radio specialist. We suggest that you 'BENCH TEST" the unit before installation, as we do, prior to shipment.
PAGE 5
Slidebar Manual_new_USA-5_manual_peter 1/23/2014 9:19 AM Page 5 Pairing a Bluetooth Device When connecting a Bluetooth device for the first time，you must first pair the device with the SLIDEBAR RADIO.For most devices，pairing only needs to be done once. Please follow these steps: Make sure the BT (Bluetooth) function is turned "ON" in the rad io Sub-Menu. See "Sub-Menu System" on page 13. •Ensure Bluetooth is enabled on the phone to be connected to the unit.
PAGE 6
Slidebar Manual_new_USA-5_manual_peter 1/23/2014 9:19 AM Page 6 WIRING DIAGRAM Figure 2 Figure 2 MIC IN Connection for Optional Custom Autosound CD1 Player or Bluetooth adapter PROGRAM TYPE (PTY) (Works in EURO Mode only) This function will allows you to Searching a special PTY Station in FM Mode. Turn the left front knob clockwise or counter-clockwise to select the PTY which you want, And then, Turn the right front knob clockwise to activate the Search process.
PAGE 7
TURN a store PRESS TURN area usa PRESS TURN bt on PRESS TURN bt conn PRESS TURN beep 2no PRESS TURN ct on PRESS TURN vol last PRESS left left
PAGE 8
Slidebar Manual_new_USA-5_manual_peter 1/23/2014 9:19 AM Page 8 Function See FIG.3 Radio Mode Pre-set 2 Recall/ Store Press to select the #2 radio Press to play 10 seconds of preset. each track on the flash drive or CDC Press and hold to store pre- Press again to cancel the preset 2 into memory. view scan function. Preview Scan Pre-set 3 Recall/ Store Random 4 5 Pre-set 4 Recall/ Store Select Folder Select Disc 6 Next/Previous 7 Press to select the #4 radio Press to move UP through preset.
PAGE 9
Slidebar Manual_new_USA-5_manual_peter 1/23/2014 9:19 AM Page 9 MID RANGE TURN PRESS Use this function to make a more detailed boost or cut adjustment of midrange (vocal) frequencies as follows:0.5K/1.0K/1.25K/1.5KHz.Default setting is 1.0KHz.This is a very useful mode for making very specific tonal adjustments. When selecting one of these 0.5K/1.0K/1.25K/1.
PAGE 10
Slidebar Manual_new_USA-5_manual_peter 1/23/2014 9:20 AM Page 10 Adjusting the sound properties: 1. 2. 3. 4. Press the right front knob, then release, to access the sound properties menu. Repeatedly press and release the front right knob to scroll through the available menu options. Turn the left front knob right or left to select a value for the chosen menu option.
PAGE 11
FCC Requirement Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.