REMOTE CONTROL Programming Manual and User Guide
Pair or Unpair A Remote Control 1. Initiate Learn Mode Pull down and release the TAU twice to enter learn mode. After the first tug, the drapery should start moving. The second tug should stop it. Fig. X 2. Connect the Remote On multi-channel remotes, select the channel you wish to pair to by pressing the Channel button until the LED corresponding with the appropriate channel is lit. Fig.
Using the Remote Control- Single Drapery Full open Full Closed 66% Open 66% closed Channel Selector LED Indicators Full Open- A press and release moves the drapery to the full open position. A press and hold will move the drapery towards the open position, and stop it precisely upon release. Full Closed- A press and release moves the drapery to the full closed position. A press and hold will move the drapery towards the closed position, and stop it precisely upon release.
Using the Remote Control- Dual Drapery Full open primary Full Closed Primary Full Open secondary Full Closed secondary Channel Selector LED Indicators Full Open Primary- A press and release moves the drapery plugged into the motor 1 slot to the full open position. Full Closed Primary - A press and release moves the drapery plugged into the motor 1 slot to the full closed position. Full Open Secondary- A press and release moves the drapery plugged into the motor 2 slot to the full open position.
SAFETY INFORMATION WARNING Read all warnings and instructions prior to installing the E-Wand™. Failure to follow these instructions may result in property damage or serious personal injury. CAUTION Do not use this product for anything other than its intended use. Any usage of the parts of this kit outside of its intended purposes in not covered under the warranty. CAUTION Drapery parts may have sharp edges. Use gloves to prevent cuts or abrasions whenever removing or reinstalling drapery.
RF WARNING STATEMENT The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure condition without restriction. IC STATEMENT This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
been installed; (ii) Products which have not been regularly and properly serviced in accordance with the User’s Manual or which have otherwise been neglected; and (iii) ordinary wear and tear, service and maintenance and replacement items; (iv) the Product has been used, or attempted to be used, for other than the customary usage or for other than the Product’s intended use; (v) the Product has been subject to mishandling, misuse, or abuse; (vi) the product has suffered damage resulting from lightning, powe