Installation Guide

Installation Guide
CTRL027
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING / AVERTISSEMENT
RISK OF ELECTRIC SHOCK
• Disconnect power before service installation, or maintenance of the product.
RISK OF FIRE
• Follow all relevant IEC or UL instructions and local building codes.
Prepare Electrical Wiring
Electrical Requirements
•
In case of Digital bus miswiring, mains can be present
Grounding Instructions
• The grounding and bonding of the overall system
shall be done in accordance with National electric
Code (NEC) Article 600 and local codes.
RISK OF INJURY
• Wear safety glasses and gloves during installation and servicing.
FCC / IC COMPLIANCE STATEMENTS
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
To satisfy FCC/ISED RF exposure requirements a separation
distance of 20 cm or more must be maintained between the
antenna of this device and persons during operation. Operation
at closer than 20cm is not permitted.
Pour être conforme aux limites d’exposition aux ondes RF des
normes FCC/ISED, une distance de séparation d’au moins 20 cm
doit être maintenue entre l’antenne de cet appareil et toute
personne pendant son opération. Mettre en opération cet appareil
a une distance plus rapprochée que 20 cm n’est pas permis.
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions:
• This device may not cause interference.
• This device must accept any interference, including interference
that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d’Innovation, Sciences et Dévelop-
pement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux condi-
tions suivantes :
• L’appareil ne doit pas produire de brouillage;
• L’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le
fonctionnement.
on the device. Make sure all electricity is switched off
before inspection.
WIZ100 Sensor
Save these instructions for future use.
IMPORTANT
To ensure the product warranty is valid, please ensure
all installation instructions and environmental conditions
for storage and operation are complied with.
Installation to be performed by factory trained or qualified
personnel.
Use only in the manner intended by the manufacturer. If
you have any questions, contact the manufacturer.
Save These Instructions
Daintree® Networked Wireless Integrated Sensor