Installation Guide

LightGrid Internal Node
Outdoor Wireless Control System
2.x Series
Installation Guide
CTRL042
Product Certications
FCC Statements:
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To satisfy FCC/ISED RF exposure requirements a separation distance of 20
cm or more must be maintained between the antenna of this device and
persons during operation. Operation at closer than 20cm is not permitted.
CAN ICES-
005 (B)/NMB-005 (B)
This device complies with part 15 of the FCC rules and with Innovation,
Science and Economic Development Canada's license-exempt RSS(s)
standards. Operation is subject to the following two conditions:
• This device may not cause interference
.
• This device must accept any interference, including interference that may
cause undesired operation.
Cet appareil est conforme aux partie 15 de
s regles de la FCC et aux flux RSS
exemptees de licence d'Innovation, Sciences et Development economique
Canada. Son fonctionnement est soumis aux deux conditions suivantes:
• Ce
t appareil ne doit pas provoquer d’interférences
• Cet appareil doit accepter toutes les interférence, y compris les
interferences, y compris les interferences pouvant entraîner un
fonctionnement indésirable de l'appareil.
Po
ur être conforme aux limites d’exposition aux ondes RF des normes FCC/
ISED, une distance de séparation d’au moins 20 cm doit être maintenue
entre l’antenne de cet appareil et toute personne pendant son opération.
M
ettre en opération cet appareil a une distance plus rapprochée que 20 cm
n’est pas permis.
WARNING
RISK OF ELECTRIC SHOCK
Disconnect power before servicing or installing product.
RISK OF INJURY OR DAMAGE
Unit will fall if not installed properly. Follow installation
instructions. Install in accordance with National Electric Code
and local codes.
USE NODE ONLY WITH LED AND HID LUMINAIRES
Rated up to 1000VA. Using node with any other device may
void warranty
UNPACKING
Carefully unpack unit from its packaging. Properly inspect for
defects before installing.
CAUTION
RISK OF INJURY
Wear safety glasses and gloves during installation and servicing.
RISK OF CHANGES OR MODIFICATIONS
The user is cautioned that changes or modications not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Internal node:
FCC ID: 2AS3F-90004
ISED ID: 25008 -90004