Installation Guide

ManualsBrandsCurrent Lighting Solutions ManualsElectronicsDaughter Board for 80W ZigBLE LED Driver

Installation Guide

XXXXXX | A-XXXXX

UltraMax®

Connected LED Driver (GE80MCC/Z2P1500)

BEFORE YOU BEGIN

Read these instructions completely and carefully.

WARNING / AVERTISSEMENT

RISK OF ELECTRIC SHOCK

• Turn power o before inspection, installation, or removal.

• Properly ground electrical enclosure.

RISK OF FIRE

• Follow all NEC and local codes

• Use only UL-approved wire for input/output connections.

• Minimum size 14 AWG for continuous runs.

Prepare Electrical Wiring

Electrical Requirements

• The LED driver must be connected to the mains

supply according to its ratings on the product label.

• Class 1 wiring should be in accordance with NEC.

Grounding Instructions

• The grounding and bonding of the overall system

shall be done in accordance to local electric code

of the country where the luminaire is installed.

RISQUES DE DÉCHARGES ÉLECTRIQUES

Coupe l’alimentation avant d’inspecter, installer ou déplacer le luminaire.

Assurez-vous de correctement mettre à la terre le boitier d’alimentation

électrique

RISQUES D’INCENDIE

Respectez tous les codes NEC et codes locaux.

N’utilisez que des ls approuv

s par UL pour les entrees / sorties de

connexion. Taille minimum 14 AWG.

Save These Instructions

Use only in the manner intended by the manufacturer.

If you have any questions, contact the manufacturer.

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

CAN ICES-005(A)/NMB-005(A)

Note: This equipment has been tested and found to comply with the

limits for a Class A digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area

is likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

Summary of content (3 pages)

PAGE 1
Installation Guide XXXXXX | A-XXXXX UltraMax® Connected LED Driver (GE80MCC/Z2P1500) BEFORE YOU BEGIN Read these instructions completely and carefully. WARNING / AVERTISSEMENT RISK OF ELECTRIC SHOCK • Turn power off before inspection, installation, or removal. • Properly ground electrical enclosure. RISK OF FIRE • Follow all NEC and local codes • Use only UL-approved wire for input/output connections. • Minimum size 14 AWG for continuous runs.
PAGE 2
UltraMax® Connected LED Driver (GED80MCC/Z2P1500) Installation Guide Before installing this driver: 1. Remove power from LED luminaire by switching circuit breaker powering the LED luminaire to the off position. 2. For maximum safety, LED luminaire must be grounded. Make sure LED luminaire is properly grounded with a green ground wire per National Electrical Code (NEC). 3. CAUTION: Turning off the LED luminaire’s wall switch may not remove voltage from the LED luminaire.
PAGE 3
Product Title (XXX- Series) Installation Guide This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: This device may not cause interference This device must accept any interference, including interference that may cause undesired operation of the device.