Operation Manual ACR310/312 - Mobile Validator REV 1.00 Name Signature Date Prepared by: Danny Chow Feb 7, 2011 Approved by: Eric Lee Feb 7, 2011 Advanced Card Systems Ltd. Website: www.acs.com.hk Email: info@acs.com.
ACR310/312 Table of Contents 1.0. Introduction .................................................................................................................. 3 2.0. Powering Up ................................................................................................................. 3 3.0. Main Functions............................................................................................................. 4 3.1. Smartcard reader.............................................................
ACR310/312 1.0. Introduction Advanced Card Systems Limited developed this ACR310/312 Mobile Validator for a dedicated customer Cubic Transport Systems Inc. This document describes the basic operation of ACR310/312 Mobile Validator. This Mobile Validator is a smart payment terminal which can read/write different type of smartcards. Different connectivities are provided, e.g. Wi-Fi, Bluetooth, Ethernet, GPRS/WCDMA, USB, RS485, etc., for connecting with server or other devices.
ACR310/312 A optional rechargeable battery can be inserted at the back. It acts as a backup battery when the external power is suddenly removed. So, the application software can perform some clearing tasks before going to sleep mode. 3.0. Main Functions 3.1. Smartcard reader The Mobile Validator is with a 13.56MHz smartcard reader built-in. The demo application software running at startup read cards continuously.
ACR310/312 3.4. USB Host The USB host port is compliant with USB 1.1 full speed. USB devices (e.g. mouse, keyboard, USB hub, etc) can be connected to the mobile validator via this port. For standard HID device (e.g. mouse) or mass storage device (e.g. USB drive), no driver is needed. 3.5. USB Client The USB client port is compliant with USB 2.0 high speed. The mobile validator can connect to a host (e.g. PC) via this port.
ACR310/312 3.8. RS485 A general purpose RS485 interface is provided via a RJ11 connector. It can be accessed by opening COM0 in the application software. The pin assignment is indicated as below: Pin Functions 1 Reserved (Don’t connect) 2 Reserved (Don’t connect) 3 Reserved (Don’t connect) 4 RS485 D+ 5 RS485 D- 6 GND RJ11 Connector at Mobile Validator USB Client Port 654321 3.9. GPS The mobile validator has a build-in GPS receiver with integrated antenna.
ACR310/312 4.0. FCC/IC Caution FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) this device must accept any interference received, including interference that may cause undesired operation.