Flange Mounting Kit Instruction Manual
(3x) (3x) 1 Prepare the panel opening per the diagram on page 6. 2 Install the Front Flange using three (3) 10-32 x 7/8" Socket Pan Head Screws and three (3) 10-32 Nuts. 3 Tighten using a 3/8" wrench and the provided Hex Key. Note: If necessary, the 10-32 Nuts can be installed from the front, working through the cut-out hole.
Detail, showing the two (2) 10-32 Nuts mounted on the 10-32 x 7/8" Socket Pan Head Screw. View rotated 270° (3x) 4 Install one (1) additional 10-32 Nut onto each screw. Hand-tighten only.
(3x) 5 From the back side, install the Rear Port XP2i. 6 Install the Rear Flange over the XP2i using three (3) 10-32 Nuts. Tighten using a 3/8" wrench until the Rear Flange securely clamps the XP2i. Note: Do not overtighten.
Detail, showing the two (2) 10-32 Nuts (jam nuts) tightened against either side of the Rear Flange. 7 Back out each of the three (3) hand-tight nuts installed in step 3, until they fit snugly against the Rear flange. 8 Using a 3/8" wrench, tighten each of the three (3) nuts against the Rear Flange. Note: Due to the use of double nuts (aka jam nuts) the final assembly will be vibration resistant.
Flange Mounting Diagram Ø Mounting Bolt Hole 0.22" (5.6mm) Ø Panel Opening 4.94" (125.5mm) 120˚ 120˚ 120˚ Ø Mounting Bolt Circle 5.38" (136.
included Parts QTY 3 10-32 x 7/8" Socket Pan Head Screws QTY 1 Hex Key QTY 10 10-32 Nuts QTY 2 Flanges 7
© 2013 Crystal Engineering Corporation 708 Fiero Lane, Suite 9, San Luis Obispo, California 93401-8701 3962.