Installation Manual

Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: [phone] • fax: [phone] • www.cruxinterfacing.com
rev.020320
SWRTY-61S
Radio Replacement with Steering Wheel Retention for
Select Toyota Vehicles 2003 - Up
1 of 2
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
- Retains factory features in select Toyota vehicles while functioning with an aftermarket radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- iPhone Voice Recognition (VR) feature from SWC on select radios.
- Supports BT-HF/A2DP/AVRCP prole on select aftermarket radio models.
- Supports Pick Up/End Call, Pick up and Toggle between 1st and 2nd incoming call, AVRCP Track, Seek.
- Retains factory Aux Input.
- EIA color coded wiring for easy installation.
PRODUCT FEATURES:
PARTS INCLUDED:
INSTALLATION DIAGRAM:
SWRTY-61S MODULE SWRTY-61S HARNESS SWC CABLE
AFTERMARKET
RADIO
SWRTY-61S SWC
MODULE
+12V Constant Yellow
+12V ACC Red
Ground Black
Illumination Orange
Amp Turn-On
Blue/ White
Power Antenna Blue
Right Front (+) Gray
Right Front (-) Gray/Black
Left Front (+) White
Left Front (-) White/Black
Right Rear (+) Violet
Right Rear (-) Violet/Black
Left Rear (+) Green
Left Rear (-) Green/Black
Audio Input
Red/White RCA
(Retains Factory AUX Input
in Select 2007-Up Vehicles)
TO FACTORY
HARNESS
12-Pin Black
Connector
20 PIN
10 PIN
6 PIN
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS” section.
AFTERMARKET
RADIO SELECTOR
(See Chart)
TOYOTA
SWC SETTING
(OFF ON OFF ON)
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
4-Pin
Connector
Cap or insulate if
not being used
Kenwood/JVC (BLUE / YELLOW)
Insulate with tape
if not being used
To aftermarket
radio SWC port