Specification Sheet

- Interface includes Audio / Video Input to connect an extra A/V source.

- Spare Tire mount reverse camera included.

- Activates MYGIG Screen for enabling Video features.

- Supports vehicles with manual transmission. See note below.

- Plug and Play connections for ease of use.

NOTE: Does not supply +12V Reverse Trigger on vehicles with manual transmission. Camera power

must be tapped from the +12V reverse light wire instead.

- MyGig Navigation Radio

CH-75WT MODULE

CH-75WT HARNESS

CH-01S CAMERA

Rev.092617

1 / 3

PAGE 1
- Interface includes Audio / Video Input to connect an extra A/V source. Spare Tire mount reverse camera included. Activates MYGIG Screen for enabling Video features. Supports vehicles with manual transmission. See note below. Plug and Play connections for ease of use. NOTE: Does not supply +12V Reverse Trigger on vehicles with manual transmission. Camera power must be tapped from the +12V reverse light wire instead. - MyGig Navigation Radio CH-75WT MODULE CH-75WT HARNESS CH-01S CAMERA 1/3 Rev.
PAGE 2
DIP SWITCH SETTING Please note that the WHITE 12V Reverse Output wire does not supply power on vehicles with manual transmission and should be insulated to avoid from shorting. Connect the camera power to the OE reverse light +12V wire instead. DIP 1 DIP 2 DIP 3 DIP 4 DIP 5 DIP 6 OFF ON OFF OFF OFF ON VIM Disable Rear-View Camera Enable N/A Option for GREEN Wire CAN Termination Radio Side CAN Termination Car Side 1. 2. 3. 4. 5. 6. 7. Remove the outside mounted spare tire.
PAGE 3
The parking lines are there to assist you while reversing. To activate the parking lines simply cut/disconnect the WHITE loop wire located near the 4 pin camera connector. GREEN What the Lines mean: Green Line: CLEAR Yellow Line: GETTING CLOSE Red Line: WARNING - VERY CLOSE YELLOW RED VES will be your source for the AV Input. To access the VES button, press the RADIO/MEDIA button on the left side of the radio. The VES button is only active after the interface is properly installed.