CrownWall 4’ x 8’ Panel Kit CrownWall TM Installation Instructions 8’ 4’ 32 sq. ft. WATCH OUR INSTALLATION VIDEOS: garageroyalty.
CrownWall 4’ x 8’ Panel Kit What’s Included 1 6” Panel 2 pcs 96” (244 cm) CrownWall Panels 8 pcs ” (3.
CrownWall 4’ x 8’ Panel Kit Step 1 Decide where and how high you would like to start your CrownWall. Measure the starting point from the floor up and mark the spot with a pencil. Step 2 Using the stud finder, locate and mark all studs in between the starting stud and finishing stud. Panels must start and finish on studs. Studs should be centered 16” (41cm) apart in order to support 100lbs (45kg) per square foot. Use a level to mark along their length as you will need to screw each panel into each stud.
CrownWall 4’ x 8’ Panel Kit Step 4 Install J-Trims on each side of the first panel. Use a level to make sure the trim is perpendicular to the panel. Screw through both the upper channel of the panel and the J-Trim into the start and finish studs. The longer side of the J-Trim should be flush to the wall. Step 5 Slightly curve and slide your next panel into the J-Trim. Clip the next panel into the previous one.