Installation Guide

ManualsBrandsCrown Equipment ManualsElectronicsQPR2 Ring

1 | Page

INSTALLATION GUIDE

Radio board is to be installed in a Crown designed and approved enclosure. It is only to be attached to a

Crown designed and approved module that contains the proper settings. Transmit setting are not

adjustable by the user. Radio board proportion of the module contains the Silicon Labs BGM121N256V2

BLUETOOTH 4.2 transceiver module (U4). Module is approved with a 2.14 dBi or less antenna. Radio

board is to not be modified in any way. Antenna Connector (J8) is only used for development and not to

be connected to or utilized in any way.

Summary of content (5 pages)

PAGE 1
INSTALLATION GUIDE Radio board is to be installed in a Crown designed and approved enclosure. It is only to be attached to a Crown designed and approved module that contains the proper settings. Transmit setting are not adjustable by the user. Radio board proportion of the module contains the Silicon Labs BGM121N256V2 BLUETOOTH 4.2 transceiver module (U4). Module is approved with a 2.14 dBi or less antenna. Radio board is to not be modified in any way.
PAGE 2
FCC This device complies with Part15 of the FCC Rules. Operation is subject to the following two conditions. (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by Crown Equipment Corporation could void the user’s authority to operate the equipment.
PAGE 3
End Product Labeling The BGM121 module is not labeled with its own FCC ID because of its small physical size.
PAGE 4
ISEDC This radio transmitter (IC: 9016A-HD4000A) has been approved by Industry Canada to Operate with the embedded chip antenna. Other antenna types are strictly prohibited for use with this device. This device complies with Industry Canada’s license-exempt RSS standards. Operation is Subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause Undesired operation of the device.
PAGE 5
configurations or co-location with another transmitter), then the IC authorization is no longer considered valid and the IC ID cannot be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate IC authorization. End Product Labeling The BGM121/BGM123 module is not labeled with the IC ID because of its small physical size.