Quick Reference Guide

Quick Reference
Intended use of the device
The D SCAN
®
AUTHENTICATOR CF is a full colour image and full page reader for the
intended use of acquisition and transmission of personal and document data. It is intended for the
use in IT-devices area and the operation and installation must be in connection with suitable
computer equipment. When operating, the electrical installation and cabling must comply with
the IEC 60950 standard.
The device has the capability to capture images of an entire data page of any ID document in
different illuminations (visible, IR, coaxial and UV light) and to read RFID chip data contactless
using a 13.56 MHz RFID Transceiver. To capture and transmit data the high speed USB 2.0
interface will be used.
The additionally installed card reader provides a contact interface, which allows to read the chip
data of ID cards. The operation and display of results is controlled by the special software as well
as all functions.
Basic health and safety instructions
To ensure safe operation of the D SCAN AUTHENTICATOR CF:
• All persons who operate the D SCAN AUTHENTICATOR CF must observe the guidelines and
particularly the safety precautions outlined in this document and according to related country
regulation requirements.
• You must observe restrictions on the use of the device in potentially hazardous atmospheres
such as fuel depots, chemical plants and areas where the air contains chemicals or particles
(such as grain, dust, or metal powders) and any other area where you would normally be
advised to turn off your vehicle engine.
• Transmitted radio frequency energy may interfere with some hearing aids, pacemakers or other
medical devices if the person is positioned too close to the document reader.
• To reduce the RF exposure refer to your related country regulation requirements. See the
specifications table and read the User Manual on the CD-ROM for detailed information.
• Switch off the document reader if not in use.
• Do not open the device. Repairs are only allowed by Cross Match Technologies. Changes or
modifications not expressly approved by Cross Match Technologies could void the user's
authority to operate the equipment.
D SCAN
®
AUTHENTICATOR CF
Device: Documentreader
Type: D SCAN AUTHENTICATOR CF
Model-Nr.: RJ0479 V2
Rated Input: 18-24 V DC / 1 A, external power supply
Signal Inputs/Outputs: 1 x USB 2.0
RFID operating frequency: 13,56 MHz
RFID magnetic field strength: max. 4,0 A/m
RFID transmitting power: max. 200 mW
Dimensions, W x H x D:
263 mm x 150 mm x 212 mm
[10.35 in x 5.90 in x 8.35 in]
Weight: 2,3 kg [5.1 lbs]