Use & care guide

ManualsBrandsCrosley ManualsDomestic AppliancesGAS RANGE

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

p/n 316259336 EN_SP (0408)

Clearances and Dimensions

1. Location—Check location where

the range will be installed. Check

for proper electrical and gas

supply, and the stability of the

floor.

2. Dimensions that are shown must

be used. Given dimensions

provide minimum clearance.

Contact surface must be solid

and level.

Provide Proper Fuel Type

Before Proceeding: Your range is preset to operate on natural gas only. This

model was shipped convertible from the factory with the necessary parts and

conversion instructions supplied.

DO NOT attempt to convert this range to LP/Propane settings without

the proper LP/Propane conversion kit provided with the range or obtained from your

dealer. Follow all instructions provided with this conversion kit.

Español - Páginas 9-16

30" GAS RANGE INSTALLATION INSTRUCTIONS

(For Models with Sealed Top Burners)

If the information in this manual is not followed

exactly, a fire or explosion may result causing property

damage, personal injury or death.

FOR YOUR SAFETY:

— Do not store or use gasoline or other flammable vapors

and liquids in the vicinity of this or any other appliance.

— WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone

in your building.

• Immediately call your gas supplier from a neighbor's

phone. Follow the gas supplier's instructions.

• If you cannot reach your gas supplier, call the fire

department.

— Installation and service must be performed by a qualified

installer, service agency or the gas supplier.

44 5/8"

Note: For appliances installed in the

State of Massachusetts see page 2.

Refer to your serial plate for

applicable agency certification

Summary of content (8 pages)

PAGE 1
30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Sealed Top Burners) INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.
PAGE 2
30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Sealed Top Burners) Important Notes to the Installer Never leave children alone or unattended in the area where an appliance is in use. As children grow, teach them the proper, safe use of all appliances. Never leave the oven door open when the range is unattended. 1. Read all instructions contained in these installation instructions before installing range. 2.
PAGE 3
0" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Sealed Top Burners) A. Locate the Bracket Using the Template - (Bracket may be located on either the left or right side of the range. Use the information below to locate the bracket if template is not available). Mark the floor or wall where left or right side of the range will be located. If rear of range is against the wall or no further than 1-1/4" from wall when installed, you may use the wall or floor mount method.
PAGE 4
30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Sealed Top Burners) C. Level and Position Range - Level range by adjusting the (4) leveling legs with a wrench. Note: A minimum clearance of 1/8" is required between the bottom of the range and the leveling leg to allow room for the bracket. Use a spirit level to check your adjustments. Slide range back into position.
PAGE 5
30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Sealed Top Burners) 5. Read electrical connection details below and connect electricity to range. Before servicing, disconnect electrical supply at circuit breaker, fuse or power cord. Electric Requirements: A dedicated, properly grounded and polarized branch circuit protected by a 15 amp. circuit breaker or time delay fuse. See serial plate for proper voltage.
PAGE 6
30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Sealed Top Burners) Burner sizes and locations Burner Assembly Front of cooktop Fig. 1 REMEMBER — DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface burners are in use. 7.
PAGE 7
30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Sealed Top Burners) 8. Adjust the "LOW" Setting of Surface Burner Valve (Linear Flow Valves Only): setting, the glowing igniter will go off. The burner flame will go "out" in 20 to 30 seconds after the igniter goes "OFF." To maintain any given oven temperature, this cycle will continue as long as the dial (or display) is set to operate. After removing all packing materials and literature from the oven: a) Set oven to BAKE at 300ºF.
PAGE 8
30" GAS RANGE INSTALLATION INSTRUCTIONS (For Models with Sealed Top Burners) Care, Cleaning and Maintenance Refer to the Use & Care Guide for cleaning instructions. 11. Air Shutter-Broil Burner If removing the range is necessary for cleaning or maintenance, shut off gas supply. Disconnect the gas and electrical supply. If the gas or electrical supply is inaccessible, lift the unit slightly at the front and pull out away from the wall.