PART LIST Top Panel Left Side Panel | Right Side Panel | Upper Fixed Shelf| Lower Fixed Shelf 1PC 1PC 1PC 1PC 1PC Bottom Rail Left Door Right Door Drawer Front Drawer Back Panel Panel 1PC 1PC 1PC 1PC 1PC Drawer Left Side |Drawer Right Side| Drawer Bottom Back Panel Top Rail Panel Panel Panel 1PC 1PC 1PC 1PC 1PC P Adjustable Shelf 1PC
HARDWARE LIST ADDITIONAL TOOLS (Not Provided) Note: It is not recommended to use power tools during assembly.
Please do not use tools to assemble this unit unless specifically indicated. Unlocked Locked Reference the images above any time the instructions state "lock the hardware”. Note: Be sure to check all hardware is locked when completed. Step 1. Attach magnet (part #3) to top panel (part A) using round head screws (part #4) and fillips head screwdriver. Attach knob (part #6) to drawer front panel (part I) using short round head bolt (part #7) and fillips head screwdriver.
Step 2. Attach drawer left side panel (part K) and drawer right side panel (part L) to drawer back panel (part J) using small wood dowels (part #2) and lock the hardware. Slide drawer bottom panel (part M) into grooves of drawer left side panel (part K}, drawer right side panel (part L) and drawer back panel (part J).
Step 4. Attach top rail (part O) and bottom rail (part F) to right side panel (part C) using large wood dowels (part #1). Attach left side panel (part B) to top rail (part O), upper fixed shelf (part D), lower fixed shelf (part E} and bottom rail (part F) using large wood dowels (part #1) and lock the hardware. #1 % x6 Step 5.
Step 6. Carefully turn unit upright. Attach back panel (part N) to assembled unit (parts using screws (part #13) and fillips head screwdriver. Tighten bottom rail (part F) to left side panel (part B) and right side panel (part C) using barrel nuts (part #11), long bolts (part #10) and Allen wrench (part #14). — -& #10 #10~x4 x20 #11 #145» x 1 wd Step 7. Place shelf holders (part #12) into desired position and then slide adjustable shelf (part P) into place.
Step 8. Insert drawer into cabinet. Step 9. Drill two 11/32" holes where you want to secure your cabinet. The drilled holes will be at the same height as the holes in back panel (part N). Tap wall anchors (part #16) into the holes. Secure the cabinet to the wall using long round head screws (part #15) into wall anchors (part #16) and fillips head screwdriver.