PART LIST Top Panel Left Panel Right Panel Left Partition Right Partition Panel Panel 1PC 1PC 1PC 1PC 1PC Bottom Panel Left Door Right Door Middle Adjustable| Adjustable Shelf Shelf 1PC 1PC 1PC 1PC PCS 188 Middle Back Panel| Back Panel Top Rail Support Leg 1PC PCS 1PC PCS
HARDWARE LIST 28*30mm Wood Dowel Magnet Round Head Handle Round Head Bolt crew 18 PCS (Extra 1) PCS 4 PCS (Extra 1) PCS 4 PCS (Extra | Barrel Nut Long Bolt Short Bolt Shelf Holder Long Screw 4 PCS 4 PCS (Extra 1) | 4 PCS (Extra 1) 12 PCS PCS I Adjustable Leveler| Short Screw Allen Wrench 6 PCS 30 PCS (Extra 1) 1PC ADDITIONAL TOOLS (Not Provided) Note: It is not recommended to use power tools during assembly. & Phillips Head Screwdriver Note: Wood dowels are intended for alignment.
Please do not use tools to assemble this unit unless specifically indicated. Locked Unlocked Reference the images above any time the instructions state "lock the hardware”. Note: Be sure to check all hardware is locked when completed. Step 1. Attach magnets (part #2) to partition panels (parts D & E) using round head screws (part #3) and fillips head screwdriver. Attach adjustable levelers (part #11) to left panel (part B), right panel (part C) and support legs (part N).
Step 2. Attach partition panels (parts bottom panel (part F) using wood dowels (part #1), barrel nuts (part #6), long bolts (part #7) and Allen wrench (part #13). Attach left panel (part B) and right panel (part C) to bottom panel (part F) using wood dowels (part #1), short bolts (part #8) and Allen wrench (part #13).
Step 4. Attach top panel (part A) to assembled unit (parts using wood dowels (part #1) and lock the hardware. #1 x8 Step 5. Lay assembled unit upside down. Insert middle back panel (part K) and back panels {part L} into the grooves of top panel (part A), left panel (part B) and right panel (part C).
Step 6. Secure back panels (parts top panel (part A), left panel (part B), right panel (part C) and bottom panel (part F) using short screws (part #12) and fillips head screwdriver. #12 wx 30 Step 7. Carefully turn unit upright. Place shelf holders (part #9) into desired position and then slide adjustable shelves (parts | & J) into place.
Step 8. Attach doors (parts placing bottom pin hinge (per-installed in door) in the per-drilled hole of bottom panel (part F). Then depress the top spring-loaded pin hinge so it can be placed in the per-drilled hole of top panel (part A). NOTE: Be sure top and bottom pin hinges are fully extended to secure doors in place. Step 9. If you would like to add an electric fireplace (*Not Included), please follow step 10.
Step 10. Fireplace Assembly: Remove middle adjustable shelf (part |) and middle back panel (part K). Install electric fireplace (*Not Included) into the unit following the assembly instructions of the electric fireplace.