User's Manual



Usermanual

The CZ-319.5-DW5Y is a smart encrypted Door and Window sensor that is compatible with

2GIG.com and Honeywell.com alarm panels. This smart sensor transmits a signal to the

specified alarm panels once the magnet is moved away from the larger sensor. This sensor can

do looping and has a tamper switch for added security purposes. The software is designated to

make it a faster install for alarm technicians.

Installing instructions

1. Usually the sensor is put on a doorframe or window frame. However anything that opens

and closes you can install the sensor on.

2. Make sure the sensor is 200 feet of the alarm panel. The sensor has been tested to

transmit from 363 feet to 650 feet. Please not that this is double the distance of our

competition.

3. This is a electronic device…keep it away from water/moisture. Treat it like your cell

phone that you purchased not the one your parents gave you.

4. Keep at least 6 inches from the floor

5. Temperature range 31.986 to 121.011 Degrees Fahrenhiet

6. Metals interfere with the magnet and sensor. Keep away from them. This includes utility

rooms or areas that have large areas of metal.

7. Place the sensor in an area that will open and close. For example like a door; if the door

opens up on the right side and the hinges are on the left side then you will put the larger

device (door sensor) in the upper right corner of the door. Then you will place the

magnet (smaller device) on the door frame.

8. For any changes to this manual or if you are a visual learner go to our website at

Crorzar.com and it will take you to youtube.com where you can watch more of our

installation processes, cool tricks, and product reviews.

9. Programing the sensor into the alarm panel you will need to refer to the alarm panels

installation guide or you can go to our website www.crorzar.com

and you can click on

our youtube page and we will walk you through some of the installation.

10. You should test the alarm panel and sensors at least quarterly.

Replacing batteries

1. Go to our website www.crorzar.com

and click on our youtube.com channel to watch

how to do it.

2. Remove the face plate of the DW sensor. Push down the tab on top of the sensor.

Do not use a screw driver to remove the enclosure. Use a flathead screw driver to

remove the batteries. The + (positive) sign will be facing away from you when putting

in the batteries. You will know if you did it right if the alarm panel and sensor is

communicating.

PAGE 1
User manual The CZ-319.5-DW5Y is a smart encrypted Door and Window sensor that is compatible with 2GIG.com and Honeywell.com alarm panels. This smart sensor transmits a signal to the specified alarm panels once the magnet is moved away from the larger sensor. This sensor can do looping and has a tamper switch for added security purposes. The software is designated to make it a faster install for alarm technicians. Installing instructions 1. Usually the sensor is put on a doorframe or window frame.
PAGE 2
WARNING: NOT PROPERLY PUTTING IN THE BATTERIES CAN RESULT IN DAMAGING THE SENSOR. Excess heat and possible explosion. Disposal of your used batteries will need to be in accordance with your local waste recovery and recycling regulation. You will need to figure this out on your own. In the state of California you will need to go to www.dtsc.ca.gov/hazardouswaste/perchlorate for handling used batteries. You can also search on the internet. FCC Notices This device complies with Part 15 of the FCC rules.