Specifications

TelePATH 6
5) SPECIFICATIONS
General Digital voice coding 32 kbps ADPCM
Voice delay <10 ms end-to-end
Signalling Hook status, Pulse dialing, T&R polarity, Ring cadence
Data Rate Up to 14.4 kbps
(supports Bell 212A, V.32bis)
Dimensions 6.0”x6.5”x2.5” (HxWxD)
Weight 600 g
Operating temperature Extended -40° to 70° C
Humidity 0 to 95% non-condensing
Radio
Frequency Range ISM, 902-928 MHz
Channels 8
RF Modulation GMSK
Digital Modulation Direct Sequence Digital Spread Spectrum
Bandwidth 2.3 MHz
Output power 100 mW (20 dBm +/- 2 dBm)
Receiver sensitivity -90 dBm @ 10e-3 BER
Approved antennas 3 dBd / 5 dBi omni-directional “Phantom” (ANTENEX TRA9023NP)
6 dBd / 8 dBi directional (MAXRAD MYA-9153)
11 dBd / 13 dBi directional (MAXRAD MYA-91512)
Certification IC RSS210 Issue 2, FCC Part 15 Subpart B and C
Phone
Interface 600 Ω, loop-start
Ringing Amplitude > 45 Vrms @ 1 REN
Ringing Frequency 20 Hz
Ringer Waveform Sinusoidal
Battery Voltage -48 Vdc
Loop Current 25 mA
Supply Voltage 10 to 36 Vdc
Supply Power 2.75 W (max)
Power Termination Screw Terminal (2 position) + / -
Loop Termination Screw terminal (2 position) T / R
Burst-sync Termination Screw Terminal (4 position) M, D, /D, G
Cable Access Through weather resistant strain relief
Antenna Termination External reverse TNC connector
Protection Secondary
Certification IC CS03 Issue 8, FCC Part 68 Subpart D
Line
Interface > 600 Ω, loop-start
Ringing load < 1 REN
Ring detect 40 - 120 Vrms
Supply Voltage 10 to 36 Vdc
Supply Power 1.75 W (max)
Power Termination Screw Terminal (3 position) + / - / Earth ground
Loop Termination Screw terminal (2 position) T / R
Burst-sync Termination Screw Terminal (4 position) M, D, /D, G
Cable Access Through weather resistant strain relief
Antenna Termination External reverse TNC connector
Protection Primary, Secondary
Certification IC CS03 Issue 8, FCC Part 68 Subpart D
Craft Support
Power On LED
Communication Link LED
RF Receive Signal Strength Analog output, 0 to 1 Vdc
Registration Push-button switch
Monitor Port 3 pin header