Crestron CWD7545 Two-Way RF Transceiver Module Operations Guide
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Regulatory Compliance Federal Communications Commission (FCC) Compliance Statement This device complies with part 15 of the FCC Rules.
Crestron CWD7545 Two-Way RF Transceiver Module Contents Two-Way RF Transceiver Module: CWD7545 ................................................1 Functions and Features ........................................................................................................................... 1 Specifications .................................................................................................... 2 Physical Description .............................................................................
Crestron CWD7545 Two-Way RF Transceiver Module Two-Way RF Transceiver Module: CWD7545 Functions and Features The CWD7545 (hereafter referred to as “module”) is a two-way radio frequency (RF) module that utilizes the 2.4 GHz frequency band to communicate with other devices. The module operates according to the IEEE 802.15.4 specification and can be configured to minimize the possibility of interference with other devices.
Two-Way RF Transceiver Module Crestron CWD7545 Specifications The table below is a summary of specifications for the CWD7545. Specifications of the CWD7545 SPECIFICATION DETAILS Power Requirements 1.55 Watts (5VDC @ 0.310A) Operating Frequency Operating Ranges¹ 2400 MHz to 2483.5 MHz (802.15.4 compliant) Minimum Distance Maximum Distance Indoors (without repeater device) 3 ft 100 ft Available Channels 16 (numbered 11 through 26 per 802.15.
Crestron CWD7545 Two-Way RF Transceiver Module CWD7545 Detail Views Power/I-O An edge connector provides power to the module as well as serial communications between the module and wired devices. Refer to the following table for pin assignments of the module interface connector.
Two-Way RF Transceiver Module Crestron CWD7545 Setup Hardware Hookup Refer to the /I-O Pinout Signals table which shows the connections made to the module. NOTE: To prevent unit-to-unit RF interference, multiple modules operating at the same frequencies should not be installed within three to five feet of each other.
Crestron CWD7545 Two-Way RF Transceiver Module This page is intentionally left blank Operations Guide - DOC.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Operations Guide – DOC. 04.10 Specifications subject to change without notice.
