Crestron CWD6894 Two-Way RF Transceiver Module Operations Guide
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Regulatory Compliance Federal Communications Commission (FCC) Compliance Statement This device complies with part 15 of the FCC Rules.
Crestron CWD6894 Two-Way RF Transceiver Module Contents Two-Way RF Transceiver Module: CWD6922 ..............................................1 Functions and Features .............................................................................................................. 1 Specifications............................................................................................................................. 2 Physical Description ....................................................................
Crestron CWD6894 Two-Way RF Transceiver Module Two-Way RF Transceiver Module: CWD6894 Functions and Features The CWD6894 (hereafter referred to as “module”) is a two-way radio frequency (RF) module that utilizes the 2.4 GHz frequency band to communicate with other devices. The module operates according to the IEEE 802.15.4 specification and can be configured to minimize the possibility of interference with other devices.
Two-Way RF Transceiver Module Crestron CWD6894 Specifications The table below is a summary of specifications for the CWD6894. Specifications of the CWD6894-1 & -2 SPECIFICATION Operating Frequency DETAILS 2400 MHz to 2483.5 MHz (802.15.4 compliant) Operating Ranges* Minimum Distance 3 ft Maximum Distance Outdoors (without repeater device) 550 ft Available Channels 16 (numbered 11 through 26 per 802.15.4) Power Requirements 0.66 Watts (3.3VDC @ 0.20A) Dimensions (CWD6894-1) Width: 1.000 in (2.
Crestron CWD6894 Two-Way RF Transceiver Module Physical View of CWD6894-1 CWD6894-1 Detail Views SIDE TOP TOP VIEW. THROUGH BOARD (ACTUAL SIZE) Operations Guide - DOC.
Two-Way RF Transceiver Module Crestron CWD6894 Physical View of CWD6894-2 CWD6894-2 Detail Views SIDE TOP TOP VIEW. THROUGH BOARD (ACTUAL SIZE) 4 Two-Way RF Transceiver Module: CWD6894 Operations Guide - DOC.
Crestron CWD6894 Two-Way RF Transceiver Module Power/I-O Edge connectors provide power to the module as well as the communication between the module and wired devices. Refer to the following table for pin assignments of the module interface connector.
Two-Way RF Transceiver Module Crestron CWD6894 Labeling If the FCC identification number is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. This exterior label can use wording such as the following: “Contains Transmitter Module FCC ID: EROCWD6894” or “Contains FCC ID: EROCWD6894.” Any similar wording that expresses the same meaning may be used.
Crestron CWD6894 Two-Way RF Transceiver Module This page is intentionally left blank. Operations Guide - DOC.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Operations Guide – DOC. 7180A 02.11 Specifications subject to change without notice.