Crestron CWD6790R1 Two-Way RF Transceiver Module Operations Guide
Regulatory Compliance Federal Communications Commission (FCC) Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions: (1) this device may not cause interference and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.
Crestron CWD6790R1 Two-Way RF Transceiver Module Contents Two-Way RF Transceiver Module: CWD6790R1 .........................................1 Functions and Features .............................................................................................................. 1 Specifications............................................................................................................................. 2 Physical Description .....................................................................
Crestron CWD6790R1 Two-Way RF Transceiver Module Two-Way RF Transceiver Module: CWD6790R1 Functions and Features The CWD6790R1 (hereafter referred to as “module”) is a two-way radio frequency (RF) module that utilizes the 2.4 GHz frequency band to communicate with other devices. The module operates according to the IEEE 802.15.4 specification and can be configured to minimize the possibility of interference with other devices.
Two-Way RF Transceiver Module Crestron CWD6790R1 Specifications The table below is a summary of specifications for the CWD6790R1. Specifications of the CWD06790R1 SPECIFICATION DETAILS Power Requirements 0.58 W (5.0 Vdc @ 0.115 A) Operating Frequency 2400 MHz to 2483.5 MHz (802.15.4 compliant) Operating Ranges* Minimum Distance 3 ft Maximum Distance Indoors (without repeater device) 50 ft Available Channels 16 (numbered 11 through 26 per 802.15.4) RF Output Power 1.
Crestron CWD6790R1 Two-Way RF Transceiver Module Side View of Antenna CWD6790R1 Detail Views SIDE BACK Plastic Button Frame with Antenna Antenna Feed Pogo-pins Antenna PCB with Radio 10-pin Mating Connector Ports The module contains a 10-pin connector. Refer to the diagrams and descriptions that follow. Power/I-O The 10 pin connector provides power to the module as well as communications between the module and wired devices.
Two-Way RF Transceiver Module Crestron CWD6790R1 Power/I-O Pinout Signals Pin # Signal Pin # Signal REMOTE_B/CONFIG 1 +5V 6 2 TRIAC/RELAY 7 GND 3 ZERO_X 8 3.3V 4 REMOTE_A/RELAY 9 GND 5 GND 10 GND Setup Hardware Hookup Refer to the hookup diagram below, which shows the connections made to the module. Complete the connections in any order.
Crestron CWD6790R1 Two-Way RF Transceiver Module This page intentionally left blank. Operations Guide - DOC.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Operations Guide – DOC. 7559A 09.13 Specifications subject to change without notice.