Crestron CWD6660 Two-Way RF Transceiver Module Operations Guide
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Regulatory Compliance Federal Communications Commission (FCC) Compliance Statement This device complies with part 15 of the FCC Rules.
Crestron CWD6660 Two-Way RF Transceiver Module Contents Two-Way RF Transceiver Module: CWD6660 ..............................................1 Functions and Features .............................................................................................................. 1 Specifications............................................................................................................................. 2 Physical Description ....................................................................
Crestron CWD6660 Two-Way RF Transceiver Module Two-Way RF Transceiver Module: CWD6660 Functions and Features The CWD6660 (hereafter referred to as “module”) is a two-way radio frequency (RF) module that utilizes the 2.4 GHz frequency band to communicate with other devices. The module operates according to the IEEE 802.15.4 specification and can be configured to minimize the possibility of interference with other devices.
Two-Way RF Transceiver Module Crestron CWD6660 Specifications The table below is a summary of specifications for the CWD6660. Specifications of the CWD6660 SPECIFICATION DETAILS Power Requirements 1.6 Watts (5VDC @ 0.32A) Operating Frequency 2400 MHz to 2483.5 MHz (802.15.4 compliant) Operating Ranges¹ Minimum Distance 3 ft Maximum Distance Indoors (without repeater device) 550 ft Available Channels 16 (numbered 11 through 26 per 802.15.4) RF Output Power 163 mW Dimensions Width: 2.
Crestron CWD6660 Two-Way RF Transceiver Module CWD6660 Detail Views SIDE BACK RF SHIELD SMA ANTENNA t e x t 1.90 inch 4.83 cm SE06660 PCB BACK PCB WITH RADIO 16 PIN HEADER 0.74 inch 1.88 cm PIN 2 PIN 16 PIN 1 PIN 15 2.0 inch 5.08 cm Ports The module contains a 16-pin header, a 10-pin debug header, and one antenna port. Refer to the diagrams and descriptions that follow. Power/I-O The 16 pin header provides power to the module as well as communications between the module and wired devices.
Two-Way RF Transceiver Module Crestron CWD6660 Setup Hardware Hookup Refer to the hookup diagram below, which shows the connections made to the module. Complete the connections in any order. PIN 15 PIN 16 PIN 15 CONTROL PIN 1 +5V PIN 2 PIN 1 PIN 2 SE06660 PCB BACK PIN 16 NOTE: To prevent unit-to-unit RF interference, multiple modules operating at the same frequencies should not be installed within three to five feet of each other.
Crestron CWD6660 Two-Way RF Transceiver Module This page intentionally left blank Operations Guide - DOC.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Operations Guide – DOC. 7028A 04.10 Specifications subject to change without notice.
