Crestron CWD6590 Two-Way RF Transceiver Module with Integral Antenna Operations Guide
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Regulatory Compliance Federal Communications Commission (FCC) Compliance Statement This device complies with part 15 of the FCC Rules.
Crestron CWD6590 Two-Way RF Transceiver Module w/Antenna Contents Two-Way RF Transceiver Module: CWD6590 ..............................................1 Functions and Features .............................................................................................................. 1 Specifications............................................................................................................................. 2 Physical Description ..........................................................
Crestron CWD6590 Two-Way RF Transceiver Module w/Antenna Two-Way RF Transceiver Module: CWD6590 Functions and Features The CWD6590 (hereafter referred to as “module”) is a two-way radio frequency (RF) module that utilizes the 2.4 GHz frequency band to communicate with other devices. The module operates according to the IEEE 802.15.4 specification and can be configured to minimize the possibility of interference with other devices.
Two-Way RF Transceiver Module w/Antenna Crestron CWD6590 Specifications The table below is a summary of specifications for the CWD6590. Specifications of the CWD6590 SPECIFICATION DETAILS Power Requirements 0.22 Watts (3.3VDC @ 0.067A) Operating Frequency 2400 MHz to 2483.5 MHz (802.15.4 compliant) Operating Ranges¹ Minimum Distance 3 ft Maximum Distance Indoors (without repeater device) 50 ft Available Channels 16 (numbered 11 through 26 per 802.15.4) RF Output Power 2.
Crestron CWD6590 Two-Way RF Transceiver Module w/Antenna CWD6590 Detail Views 1.90 in (4.83 cm) 1.25 in (3.18 cm) Ports The module contains a 25-pin header and a 10-pin debug header. Refer to the diagrams and descriptions that follow. Power/I-O The 25 pin header provides power to the module as well as serial communications between the module and wired devices. Refer to the following table for pin assignments of the module interface connector.
Two-Way RF Transceiver Module w/Antenna Crestron CWD6590 Labeling Requirements If the FCC identification number is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module. This exterior label can use wording such as the following: “Contains Transmitter Module FCC ID: EROCWD6590” or “Contains FCC ID: EROCWD6590.
Crestron CWD6590 Two-Way RF Transceiver Module w/Antenna This page intentionally left blank Operations Guide - DOC.
6 • Two-Way RF Transceiver Module w/Antenna: CWD6590 Operations Guide - DOC.