Crestron CWD07343 Two-Way RF Transceiver Module Operations Guide
Regulatory Compliance Federal Communications Commission (FCC) Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
Crestron CWD07343 Two-Way RF Transceiver Module Contents Two-Way RF Transceiver Module: CWD07343 ............................................1 Functions and Features .............................................................................................................. 1 Specifications............................................................................................................................. 2 Physical Description – CWD07343 .........................................................
Crestron CWD07343 Two-Way RF Transceiver Module Two-Way RF Transceiver Module: CWD07343 Functions and Features The CWD07343 (hereafter referred to as “module”), with an integrated SMD antenna, is a two-way radio frequency (RF) module that utilizes the 2.4 GHz frequency band to communicate with other devices. The module operates according to the IEEE 802.15.4 specification and can be configured to minimize the possibility of interference with other devices.
Two-Way RF Transceiver Module Crestron CWD07343 Specifications The table below is a summary of specifications for the CWD07343. Specifications of the CWD07343 SPECIFICATION DETAILS Power Requirements 1.3 watts (5 Vdc @ 0.26 A) Operating Frequency 2400 MHz to 2483.5 MHz (802.15.4 compliant) Operating Ranges* Minimum Distance 3 feet Maximum Distance Indoors (without repeater device) 550 feet Available Channels Internal Antenna Dimensions * 16 (numbered 11 through 26 per 802.15.4) Antenna Max.
Crestron CWD07343 Two-Way RF Transceiver Module Physical Description – CWD07343 The module, shown below, consists of various components attached to a printed circuit board. The circuit board attaches an intended SMD mounting antenna. A 10-pin double row female connector and a 4-pin single row male connector are provided for the application-specific installation. Physical View of CWD07343 Operations Guide - DOC.
Two-Way RF Transceiver Module Crestron CWD07343 CWD07343 Detail Views LED INDICATOR USER BUTTONS 1.93 in 24V FEED THRU CONNECTION 1.95 in 5V AND IO CONNECTION RF SHIELD SMD ANTENNA 0.576 in Ports The module contains a 4-pin male header for application power and a 10-pin female header for application I/O. A 10-pin debug header is also provided. Refer to the diagrams and descriptions that follow.
Crestron CWD07343 Two-Way RF Transceiver Module Setup Refer to the hookup diagram below, which shows the connections made to the module. Complete the connections in any order. NOTE: To prevent unit-to-unit RF interference, multiple modules operating at the same frequencies should not be installed within 3 to 5 feet of each other. Hardware Hookup 5V HOST PCB Control Labeling Requirements for the Host Device The host device shall be properly labeled to identify the modules within the host device.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Operations Guide – DOC. 7649A 03.14 Specifications subject to change without notice.