User's Manual

ManualsBrandsCree ManualsElectronicsRFM MODULE

INSTALLATION INSTRUCTIONS

CM-CWC-1

Cree SmartCast™ Technology Wireless Control Module Replacement Kit

Includes: CR Series and CS Series

LPN00243X0001A0_C

1 of 2

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be

followed including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

1. Before installing turn off the power at the circuit breaker.

2. Any changes or modications to these devices not explicitly approved by

manufacturer could void your authority to operate this equipment.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE

Cree Logo

STEP 1:

Turn power off and remove old control module

from luminaire by pressing the clips located on

both sides of control module inward and pull

control module out from luminaire.

NOTE: For location of the control module

reference Figure 1 for CR luminaires and

Figure 2 for CS luminaires.

STEP 2:

Orient the new control module so that the

Cree logo is in the lower left corner. Attach the

new control module to the CR or CS luminaire

by pressing in on the clips located on the sides

of the control module and inserting it into the

designated connector.

STEP 3:

Turn power on. The new control module is

correctly installed if the Blue LED displays a 2

blink sequence.

NOTE: If the blue LED does not respond

with the two-blink sequence, please follow

the RESET instructions to return the control

module to factory defaults.

STEP 4:

On the Conﬁguration Tool, select “Replace

Devices” from the “Advanced” menu and

follow the on-screen directions.. This will

remove old device(s) from the network and

add the new device(s).

RESET

NOTE: The Blue LED is located behind the

Cree logo on the control module. The Cree

logo with illuminate blue when the Blue LED is

active.

STEP 1:

Actuate RESET button through the test hole.

Push and hold (approximately 10 sec), LED on

control module will blink fast.

STEP 2:

Release for 1 sec.

STEP 3:

Press/Hold RESET button for 0.5 sec. Light

will go to full bright and the Blue LED on

the control module should be in a 2 blink

sequence.

TO INSTALL:

Summary of content (2 pages)

PAGE 1
CM-CWC-1 Cree SmartCast™ Technology Wireless Control Module Replacement Kit Includes: CR Series and CS Series INSTALLATION INSTRUCTIONS IMPORTANT SAFEGUARDS When using electrical equipment, basic safety precautions should always be followed including the following: READ AND FOLLOW ALL SAFETY INSTRUCTIONS 1. Before installing turn off the power at the circuit breaker. 2.
PAGE 2
FCC NOTICE To comply with the FCC RF exposure compliance requirements, this device and its antenna must not be co-located or operating to conjunction with any other antenna or transmitter. This equipment should be installed and operated with minimum distance 5cm between the radiator & your body. No other antenna is authorized for use with this product. FCC COMPLIANCE STATEMENT CAUTION: Changes or modifications not expressly approved could void your authority to use this equipment.