User's Manual

Technical Specifi cations:
• Driver: 50mm Neodymium magnet
• Frequency Response: 10Hz ~ 25kHz
• Impedance: 32ohms
• Sensitivity (1kHz): 105dB/mW
• Noise Reduction Level: Up to 20dB (90%)
• Wireless Technology: Bluetooth v3.0
• Bluetooth Profi les: A2DP, AVRCP, HSP, HFP (HD Voice ready)
• Audio Codec: aptX, AAC, FastStream, mSBC, SBC
• Content Protection: SCMS-T
• Operating Frequency: 2402 ~ 2480 MHz
• Operating Range: Up to 10m / 33ft
• Power Supply: Rechargeable Lithium Ion battery, 3.7V, 620mAh
• Charge via USB: 5VDC, 500mA
• Charge / Play / Talk Time: 2 hours / 15 hours* / 21 hours*
• Net Weight: 332g / 11.7oz
FastStream allows low latency wireless bi-directional audio streaming and voice communication with
Creative BT-W1 Bluetooth USB transceiver. HD Voice requires supported handsets and mobile networks
* Without ANC
6. Right earcup indicator
7. Right earcup ANC indicator
8. Left earcup indicator
9. Micro-USB charging
connector
10. Audio Input connector
11. Invisible Microphone
12. NFC (Near Field
Communication) pad
Green and blinks slowly: ready to connect a device.
Green and blinks rapidly: attempts to connect to a Creative
ShareMe headset.
Blue and blinks slowly: connected to a paired device.
Blue and blinks rapidly: in pairing mode and is ready to pair
with a new device.
Blue and green blinks simultaneously: in an active Creative
ShareMe connection.
Red and fl ashes once: powering off the headset.
Red and blinks slowly: low battery level, charge the headset
soonest.
Red: in Airplane mode.
Red and blinks twice: in Outdoor mode.
Red and blinks thrice: in Indoor mode.
Red: charging headset. When fully charged, this indicator turns
green.
Use the supplied USB cable for charging the headset via a
laptop or computer.
Use the supplied audio cable for a wired connection to non-
wireless devices or when battery power runs out. Connect the
smaller 2.5mm diameter plug to the headset (align the triangular-
shaped connector properly) and the larger 3.5mm diameter plug
to your audio device.
Noise suppression microphone for crystal clear communications
and environmental sensing microphones for ANC processing.
Tap your NFC-enabled mobile devices here to establish
Bluetooth pairing and connection. Tap again to end connection.
Light Indicator
Connector / Port
Function
Function