GT3500H Three-Channel Guitar Amplifier User’s Guide
TABLE OF CONTENTS: Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 The Front Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 The Rear Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Suggested Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 System Block Diagram . . . . . . . . . . . . . . . . . . . . . . . . .7 Technical Specifications . . . . . . . . . . . . . . . . .
Congratulations! You are now the proud owner of the Crate GT3500H ShockWave three-channel guitar amplifier. This rugged amplifier combines outstanding features with serious clean and distorted sounds. The rear panel Effects Loop allows you to connect your effects for greater flexibility. Channel switching and reverb may be controlled by means of the supplied CFS3 footswitch. Like all Crate products, your GT3500H ShockWave amplifier is designed by musicians, and built using only the best components.
The Front Panel: 1 2 3 4 5 6 7 8 9 1. POWER: Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom of the switch depressed). The switch illuminates when the power is on. 2. REVERB: Use this control to adjust the amount of reverb effect: in its fully counterclockwise position the signal will be “dry” (without any effect). As you rotate the control clockwise the amount of reverb increases. CLEAN CHANNEL: A normal gain channel designed to give you crystal clean sounds.
10 11 12 13 14 15 16 17 18 19 20 The Rear Panel: SPEAKERS LINE OUT LINE IN 21 22 220W @ 4 Ω 350W @ 2 Ω 23 24 FOOTSWITCH SOLO RHYTHM CLEAN REVERB 25 26 FUSE 27 21. LINE OUT: When using an external effects processor, connect this jack to the input of the effect by means of a shielded signal cable. This jack also doubles as a source for a post-EQ, preamp signal to send your signal to a mixing board, recorder, powered monitor or external amplifier. 22.
Suggested Settings: Sweet & Clean: OUT N/A IN OUT IN OUT IN OUT OUT IN Just a ‘Lil Nasty: Politely Gritty: Down ‘n Dirty!: Mean & Obscene 6
System Block Diagram: BUFFER INPUT CLEAN CHNL VOL LOW MID HIGH SOLO RHTM SOLO RHTM SOLO RHTM RHYTHM/ SOLO/ CLEAN SOLO LEVEL SWITCHING CIRCUIT SOLO/ RHYTHM SOLO GAIN RHYTHM GAIN SOLO SHAPE RHYTHM LEVEL LOW MID HIGH MIX AMP LINE OUT REVERB LINE IN POWER AMP SPEAKERS DAMPING CIRCUIT 7
GT3500H TECHNICAL SPECIFICATIONS: Output Power Rating Input Impedance Total System Gain Solo Ch Rhythm Ch Clean Ch Maximum Input Signal Accepted Solo Channel Shape Control Rhythm Channel Low Control Mid Control High Control Clean Channel Low Control Mid Control High Control Power Requirements Size and Weight 350W RMS @5% THD, 2Ω, 120 VAC 470kΩ 110dB, all controls @10 88dB, all controls @10 58dB, all controls @10 7 volts peak-to-peak Proprietary Circuit 20dB range @ 80Hz 15dB range @ 1kHz 20dB range @ 10k