Installation Guide © 2007 MEI.
Table of Contents TABLE OF CONTENTS ............................................................................................................................................2 GENERAL INFORMATION.....................................................................................................................................3 REQUIRED KIT NUMBERS ....................................................................................................................................3 REQUIRED TOOLS...........
General Information This document contains information for installing the MEI easitrax SC hardware and configuration of the software that will support a retrofit application of the SC66/83 bill acceptor with RFID. NOTE: Only properly trained technicians certified by MEI are authorized to install the retrofit hardware. Installations performed by anyone else may void the warranty and the grant to use this equipment. Required Kit Numbers easitrax SC upgrade kit. Qty.
2. Use fig.1 below as a guide to line up the pins that are on the top of the antenna PCB with the matching holes that are located on the bottom of the Interface PCB. Mate the PCBs together by pressing the PCBs together. 3. Use the screws from step one and mount the topside of the antenna PCB to the bottom side of the SC series interface PCB. Screws Interface PCB Interface PCB matching holes Antenna PCB Standoffs Antenna PCB Pins. fig.1 4.
6. Open the cashbox door and remove the yellow pressure plate and spring by sliding it out. 7. Using an alcohol wipe, clean the area where the RF tag will be mounted that is shown in fig. 3. Note: Allow alcohol to completely dry before mounting the RF tag into position. 8. Mount the RF tag and reinstall the pusher plate and spring. See fig.3 Note: Mount the RF tag in the location shown to ensure proper communication with the antenna board. 9.
Easitrax SC Software Configuration 1. Open the STS program and connect to the SC series bill acceptor through the USB port. 2. Select the open button from the main screen as shown in fig. 4 3. Select the approved .xcf easitrax SC software file that is approved for your jurisdiction and click OK. 4. Select the edit box for the cashbox settings . See fig.4 fig.4 5. Select the include/change box and type in the machine asset number and select OK. See fig. 5 fig.5 6.
Note: The machine's asset number will now be assigned to that particular cashbox and will be referred to as the cashbox asset number shown in fig.5. 7. Select the write button from the main screen. See fig.6 8. Wait for the SC66 to perform a run &stack. The software configuration is complete. 9. Select the read button and verify the machine asset number is correctly displayed under the cashbox settings section. fig.
MMI Codes ENABLED / DISABLED? MMI CODE ACTION / RESULT DISABLED 5 RED BLINKS NO RF TAG DETECTED ENABLED GREEN HEAD, BLOCK 1 AND BLOCK 2 CONTAIN CORRECT ASSET NUMBER ENABLED GREEN HEAD, BLOCK 1 AND BLOCK 2 CONTAIN CORRECT ASSET NUMBER ENABLED GREEN HEAD, BLOCK 1 AND BLOCK 2 CONTAIN CORRECT ASSET NUMBER DISABLED 4 RED BLINKS HOT BOX DETECTED DISABLED 4 RED BLINKS HOT BOX DETECTED DISABLED 5 RED BLINKS NO RF TAG DETECTED ENABLED GREEN HEAD, BLOCK 1 AND BLOCK 2 CONTAIN CORRECT ASSET NU
Compliance FCC ID: QP8EASITRAX This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: This device may not cause harmful interference and this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.