Installation Instructions

SMARTIBOT v1.0 Operation
A) Load 4 x AA batteries into battery box
B) Connect barrel jack on battery box to socket on PCB, put switch on battery box to on position
C) Small Green and Blue LEDs near top of PCB should illuminate
D) Launch ‘Smartibot’ app and press first icon on left
E) Press connection icon at top of screen
F) Select Espruino SMARTIBOT from list
G) Wait until tick appears at top of screen
H) Use arrow pad and buttons to drive motors / move robot
I) Switch off when finished using switch on battery box
FCC STATEMENT：
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/ TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure
limits, Human proximity to the antenna shall not be less than 20cm (8 inches) during normal
operation
FCC ID: 2ARTF-SMB01