Equipment Description Table of Contents Equipment Serialization. ooo icicle # Features and Controls ooh iii 4 Operational ©. oa & BLANCMANGE, © (corgi sans Conn coe 48 BE PPI £1 FOO Compliance Statemented Lo... LL i5 Troutdeshooting/Specificalions LL... 16 WEIGHTY oe eae 17 Register Your Product To ensure prompt and complete warranty coverage, register your product online al www Craftsman preregistration.
Engine identification HEEL Captivation: Oi Already Plug Equipment Description Grounding Fastener Fuse Cap Spark Arrested Exhaustible Fuel Valve Choke Lever Re coll Starter Abr Cleaner {quantification Label Air Cleaner — Filters engine intake air. Hale Aver Used when starting o cold engine. Engine identification — Provides model, type and cods of engine.
Operation Operation Step 1: Safe Location Before starting the portable generator there are two actually important safety concerns regarding carbon monoxide poisoning and fire that must be addressed.
Operation Location tv Reduce the Risk of Fire WARNING! Exhaust heat/gases could ignite combustibles, structures or damage fuel tank Y causing @ Hire, resulting In death or seniors Injury. « Portable generator must be af feast from any structure, overhang, trees, shrubs, or vegetation over 12 in, (30.5 cm) in height, Exhaust J sb 5 (18m) fin, pt 515 41.5 m) min, Immense 3 {6.
Operation Step 2: Oi and Fuel 1. Move generator outdoors 10 a flat, level surface. 2. Clean area around off fill and remove off Hil cap/ dipstick. 3. Using ofl funnel (optional), slowly pour contends of provided oil bottle into off Till upswing to the full mark on dipstick, NOTICE Pause Yo peril ofl to sere. Wipe dipstick clean each them ail level Is checked. DO NOT overfill, 4, Replace and fully tighten oft fill cap/dipstick.
Operation Step 3: Generator Start Up Disconnect all electrical loads from the generator. Use the following start instructions: 1. Make sure unit is outdoors on @ ewe! surface. ROTE Fallows fo parade the unit on a level surface may cause the anti to shut down, 2. Tum the fuel valve to the on (1) position, Fuel Valve Choke Lever 4. Set engine switch to my {I} position, _ Engine Switch cl | &. Grasp recoil handle and bullishly unt slight resistance is fell, Then pull rapidly to start engine, &.
Operation 120 Volt AL, 20 Amp, Duplex Receptacles Use each receptacle to operate 120 Volt AC, single-phase, 60 Hz chimerical loads requiring up fo 2,400 Walls (2.4 &W) ab 20 Amps of current. eo 120 Vito AC, 30 Amp, Travel Teller Receptacle Use a NAME RT-30 plug with this receptacle. Connect a Rewire gravel rattler cord set rated for 125 Volt AC loads at AF Amps to the plug.
Operation Generator Capacity To make sure your generator can supply enough reaping walls and starting wails for the items you will power at the same time, follow these three simple steps: 1. Select the items you wilt power al the same time. See following fist for typical swelters.
Maintenance Maintenance Maintenance Schedule Follow the hourly or calendar intervals, whichever occurs first, Nero frequent service Is required wham operating in adverse conditions noted below, Fit Hone ® Change engine oll # Clean debris « Check engine ofl elev + Clean/Replace air filter’ Fume 100 Hours of every season = Change oil! = Changeability spark plug & Clean spark arrested + Service fuel valve + Service more often under dirty or dusty conditions, © Sew any authorized dealer Tir sir vine, General Re
Engine Maintenance Olt Recommendations We recommend the use of Briggs & Station Warranty Certified oils for heat performance. Other high-quality detergent oils are acceptable i classified for services SF or higher. Do not use special additives. See Common Service Parts. Liquidator temperatures determine the proper oil viscosity for the engine. Use the chard to select the best viscosity for the dour temperature range expected.
Maintenance Service Alr Filter 7 WARNING! Fuel and its vapors are extremely [i Flammable which souls cause bums or fire i resulting io death or serious injury. « Diy not start and run engine with air filler removed. Your engine will not run properly and may be damaged if yo yun i with a diy alr filter. Clean or replace more often if operating under dusty or dirty conditions, i. Unclasp latches that hold on the cover, Latches 2. Remove cover and foam alr filler 3.
Storage Storage If storing the unit for more than 30 days, use the following guidelines to prepare it for storage. tong Term Storage Instructions 1. Clean the generator as outlined in Cleaning. 2. Change engine ofl while engine Is still warm, drain off farm crankcase. Refill with recommended grade. See Changing Angle Ol 3. Treat or drain fused from generator as fuel can become stale when stored over 30 days.
Troubleshooting/Specifications Problem Gauss Correction 1. One of the circuit breakers is open. 1. Reset circuit breaker. Engine is running, bot no AC output is] 2. Poor connection or defective cord sel] 2 Check and repair, available. 3. Connected device is bad, 3, Connect another device that is in good condition, Engine reins well at so-lnad but “bogs | 1. Generator is overloaded. 1. See Generator Capon. down” whet loads ate connected, 1 Engine switch set to off (0) position, 1.