Owner's Manual

#14 - 10 x 3/4 Cross-tip Screw
(Qty: 4)
#14 - 10 x 5/8-in Hex Screws
(Qty: 16)
HARDWARE INCLUDED:
26-INCH CABINET HARDWARE
CASTER INSTALLATION (26-INCH CABINET)
TOOLS REQUIRED:
3/8-in Wrench
7/16-in Wrench
Cross-tip Screwdriver
Items Needed:
#14 - 10 x 5/8-in Hex Screws (Qty: 16)
3/8-in Wrench
NOTE: Not all assembly instructions will relate to your model.
SIDE HANDLE ATTACHMENT
Items Needed:
#14 - 10 x 3/4 Cross-tip Screw (Qty: 4)
Cross-tip Screwdriver
Process:
• Attach the side handle using (4) #14 - 10 x 3/4 Cross-tip
screws.
• Hand tighten. Do not overtighten.
Process:
NOTE: Use adequate personnel for this operation.
NOTE: Failure to install caster channels may result in
premature cabinet failure.
• Place the unit on its top. Use packaging material to
protect the paint nish.
• Position caster channels on the cabinet. Notched anges
should be toward the outside and pointed up.
• Attach casters and caster channels using (4) #14 - 10
x 5/8 Hex Screws for each caster. Mount both swivel
casters on the same side of the cabinet as the side
handle.
• Wrench tighten all screws. Do not overtighten.
• Return the unit to its upright position.
1/4 - 20 x 5/8 Screw (Qty: 16)
#14 - 10 x 3/4-in Screws
(Qty: 16)
HARDWARE INCLUDED:
40- & 52-INCH CABINET HARDWARE
1/4-in Nut (Qty: 16)
Notches
in front
Caster channels
Notches
in back
HARDWARE
2
ASSEMBLY
CASTER INSTALLATION (40-INCH CABINET)
Items Needed:
1/4 - 20 x 5/8 Screw (Qty: 16)
1/4-in Nut (Qty: 16)
7/16-in Wrench
Process:
NOTE: Use adequate personnel for this operation.
• Remove the bottom drawer by following the drawer
removal instructions.
• Lay the cabinet down on its back. Use packaging
material to protect the paint nish.
• Mount both swivel casters on the same side of the cart
as the side handle.
• Attach each caster using (4) 1/4-20 x 5/8 screws and
(4) 1/4” nuts per caster.
• Wrench tighten all screws.
• Return the cart to its upright position.