620263-963 SEARS OWNERS MANUAL MODEL NO. 31 5.11690 CAUTION' Read Rules for ® Safe Operation and Instructions Carefully SANDER DUAL MOTION DOUBLE INSULATED SAVE THIS MANUAL FUTURE FOR REFERENCE Introduction Operation Repair Parts .'€ % ' <;.{UL)I!; ',_ Designed SEARS, ROEBUCK 620263,963 exclusively for and sold only by AND CO., Dept. 698/731A, Sears Tower, Chicago, IL 60684 PRINTED IN U. S A.
FULL ONE YEAR WARRANTY ON CRAFTSMAN SANDER If this Craftsman Sander fails to give complete satisfaction within one year from date of RETURN IT TO THE NEAREST SEARS STORE THROUGHOUT THE UNITED STATES and replace it, free of charge. If this sander is used for commercial or rental purposes this warranty applies for only 90 the date of purchase. This warranty gives you specific legal rights, and you may also have other rights which state to state. SEARS, ROEBUCK AND CO. DEPT.
RULES FOR SAFE OPERATION (Continued) 11. USE SAFETY GLASSES with all tools. Also face or dust mask if cutting operation is dusty. 12. DON'T ABUSE CORD. Never carry tool by cord or yank it to disconnect from receptacle. Keep cord from heat, oil and sharp edges. 13. SECURE WORK. Use clamps or a vise to hold work. It's safer than using your hand and it frees both hands to operate tool. 14. DON'T OVERREACH. Keep proper footing and balance at all times. 15. MAINTAIN TOOLS WITH CARE.
OPERATION For ease of operation your sander has a front handle and a rear handle. These handles allow two-hand operation which aid in maintaining control and keeping sanding area level with workpiece. Fig. 1 SAN DPAPER SELECTION Selecting the correct size and type sandpaper is an extremely important step in achieving a high quality sanded finish. Aluminum oxide, silicone carbide, and other synthetic abrasives are best for power sanding.
OPERATION (CONTINUED) MOTION SELECTIONS The dual motion feature of your sander provides required motion for any sanding application. The orbital motion provides fast cutting action when you need to remove old finishes, smooth rough wood, cut stock down to required dimensions, or sand surfaces to be painted. Straight line motion provides fine finish sanding on work to be stained or varnished. WARNING: NEVER CHANGE THE MOTION SET. TING WHILE THE SANDER IS "ON". Fig. 3 SETTING MOTION 1. Unplug the sander.
OPERATION (Cont.) GENERAL WHEN SERVING USE ONLY IDENTICAL REPLACEMENT PARTS When electric tools are used on fiberglass boats, sports cars, wallboard, spackling compounds, or plaster, it has been found that they are subject to accelerated wear and possible premature failure, as the chips and grindings are highly abrasive to bearings, brushes, commutator, etc.
CRAFTSMAN SANDER ,_ MODEL NUMBER 315.11690 4 SEE BACK Key No. 1 2 3 4 PAGE PARTS ORDERING PARTS Pad Number 610515-001 612007-001 607119-001 989522-001 t** 620263-963 ***Complete FOR INSTRUCTIONS LIST De_ription Quan. Logo Plate ........................................ Data Plate ........................................ Motion Setting Decal ............................... Cushion ..........................................
SEARS SANDE OWNERS MANUAL DUAL MOTION DOUBLE iNSULATED SERVICE MODEL NO. 315.11690 HOW TO ORDER REPAIR PARTS Now that you have purchased your Sander, should a need ever exist for repair parts or service, simply contact any Sears Service Center and most Sears, Roebuck and Co. stores. Be sure to provide all pertinent facts when you call or visit. The model number the plate attached of your Sander to the housing.
