Manual

To Store Your Accessories
1. Your Sears Craftsman wet/dry vac is
designed to provide better stability,
mobility and accessory storage with the
addition of the caddy. Located at the
rear of the caddy are five storage pock-
ets. Wet/dry vac accessories may be
conveniently stored here while not in
use. The center storage pocket is spe-
cifically designed for the wet nozzle.
Vac Assembly
1.Locate the lid/float/cage and the drum/
caddy assemblies (assembled earlier).
2. Position the lid assembly with the inlet
of the unit located in line with the drain
plug on the dust drum,
3. To assemble the lid assembly to the
drum/caddy, position the lid retention
hinge to clasp the lip of the dust drum.
To ensure proper lid assembly onto the
drum/caddy assembly, angle the lid
assembly, with the drum latch up, at
45°
4. Pivot the lid assembly down until it rests
on the drum/caddy assembly,
5. Rotate the drum latch down until you
hear the latch snap over the lip of the
drum.
6. To check that the lid assembly is prop-
erly assembled to the drum/caddy, try
to lift up on the area of the lid above the
lid retention hinge. If the lid assembly
and drum/caddy assembly do not sepa-
rate with the drum latch latched, the
assembly is correct. If the assemblies
do separate, unlatch the drum latch and
try to assemble it again making sure the
lid retention hinge is located under the
lip of the dust drum.
NOTE: For best appearance of the unit,
the inlet of the vac should be located
above the drain plug.
Drain
Lid
Retention
Hinge
Lid
Retention
Hinge
8