Manual

Filter Assembly
1. Carefully slide the filter over the tilter
cage, sliding itover the center ring cov-
ering the 3 slots until the tilter stops
against the lid.
2. Place the hole in the filter plate over
threaded screw of the fgter cage.
3, Gently push on the filter plate to seat
the rubber ring of the filter inside the cir-
cular channel of the tilter plate.
4. Place filter nut onto threaded screw and
tighten it down. Finger tighten only.
NOTE: Lever of tilter nut should be away
from plate as shown.
IMPORTANT: Do not overtighten as this
may deform or crack the tilter plate, filter
cage or the filter.
NOTE: Your filter has a red stripe that
matches an in-store displayer, When you
visit your local Sears store, just remember
the color of your stripe for the correct size
filter.
Filter
Stripe
Threaded "_ _,_,,,_
_l,Screw _ge
Accessory Caddy Assembly
Locate the two 5-1/4" wheel assemblies
and the two dual wheel casters in the car-
ton. The casters are designed to fit in the
front of your new accessory caddy and
the larger wheels fit the rear of the caddy.
To Install the Wheels/Casters
1. Place the accessory caddy upside
down on a flat surface as illustrated.
2. Insert the dual wheat casters into the
bottom of the accessory caddy as
shown (2 places).
3. Push on the caster until the flange on
the caster stem is inserted all the way
into the socket. You will be able to hear
the flange snap into the socket. The
caster will swivel easily when position-
ing is correct.
5-1/4" Wheel Assembly
Caster
Accessory Caddy
6