Owner`s manual

Assembly

Introduction

In order to get the most enjoyment out of your radial saw it is important that the machine by properly

assembled, adjusted, and aligned. This procedure, although not difficult, takes time; perhaps eight

hours or longer for the inexperienced user. However, after this initial set-up a weekly trine-up can be

completed in approximately ten minutes by checking the alignment and only adjusting those settings

which are incorrect.

Identify Parts

The following parts are included:

Note: Before beginning assembly, check that

all parts are included. If you are missing any

part, do not assemble the saw. Contact your

Sears Service Center to get the missing part.

Sometimes small parts can get lost in pack-

aging material. Do not throw away any

packaging until saw is put together. Check

packaging for missing parts before contact-

ing Sears. A complete parts list (Repair

Parts) is at the end of the manual. Use the

list to identify the number of the missing

part.

All models include:

A. Basic Saw Assembly ......... 1 s e o E

B. Rear Table .......................... 1 F

C. Spacer Table ...................... 1 __/

D. Fence (wooden) ................. 1

E. Front Table ........................ 1

F. Table Support .................... 2

G. Loose Parts Bag(s) ............ *

H. Bag Containing

Accessory Guard ............... 1

Orllv models with leg set include:

J. Leg ..................................... 4

K. Stiffener, L.H ..................... 4

L. Stiffener, R.H ..................... 4

Only Contractor model includes:

M.Lower Stiffener .................. 4

* Number varies; bags can contain other

smaller bags. Note: To make assembly easi-

er keep contents of each bag together and

separate from contents of other bags.